User manual PHILIPS LTC1133

[. . . ] Heed Warnings All warnings on the unit and in the operating instructions should be adhered to. Follow Instructions All operating and use instructions should be followed. Cleaning Unplug the unit from the outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. [. . . ] When the unit exhibits a distinct change in performance - this indicates a need for service. Replacement Parts When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock or other hazards. 3 14. Safety Check Upon completion of any service or repairs to this unit, ask the service technician to perform safety checks to determine that the unit is in proper operating condition. FCC INFORMATION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: s s s s Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into and outlet on a circuit different form that to which the receiver is connected. Consult the dealer or an experienced radio/ TV technician for help. Shielded interface cables and A. C. power cord, if any, must be used in order to comply with emission limits. Changes or modification not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. 4 SAFETY PRECAUTIONS CAUTION:TO REDUCE THE RISK OF ELECTRICAL SHOCK, DO NOT OPEN COVERS. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. This label may appear on the bottom of the unit due to space limitations. The lightning flash with an arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of un-insulated " dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constiuce a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. ATTENTION: INSTALLATION SHOULD BE PERFORMED BY QUALIFIED SERVICE PERSONNEL ONLY IN ACCORDANCE WITH THE NATIONAL ELECTRICAL CODE OR APPLICABLE LOCAL CODES. Attention: Installation should be performed by qualified service personnel only in accordance with the National Electrical Code or applicable local codes. 1. 1 TABLE OF CONTENTS IMPORTANT SAFEGUARDS . . 1. 1 FEATURE OF FlexiDome Series Monochrome and Color Fixed Dome Cameras . . 1. 4 INSTALLATION for Surface ( Wall ) Mount . [. . . ] This could be result in picture distortion (distance between lens and viewing window of bubble is too big). 1. 9 4. 7 Adjust the lens position; and make sure the wanted view area has been covered. Then fix the position of camera module by fastening 2 screws on the sides of metal frame. 360° 180° 4. 8 Put the dome bubble onto housing cover. 4. 9 Rotate the bubble to make sure the lens is positioning to bubble's transparent part. 1. 10 5 TECHNICAL DATA Electrical (Monochrome Version) Pick up device Num. of pixel elements Scanning system : : : 1/3-inch CCD image sensor CCIR 512 (H) x 582 (V) EIA 512 (H) x 492 (V) 2:1 interlaced CCIR 15, 625 kHz * 50 Hz EIA 15, 750 kHz * 60 Hz CCIR 380 TVL (H) EIA 380 TVL (H) 0. 3 Lux (F1. 4) 48 dB 29 dB (max. ) auto electronic shutter or flickerless mode switchable up to 1/100, 000 sec on/ off 0. 45 internal synchronization 3. 6mm fixed lens 6. 0mm fixed lens 1. 0 Vp-p, 75ohm unbalance (composite) 12 Vdc +/- 10%, 150mA Resolution Minimum illumination S/N ratio Auto gain Control Shutter control mode Electronic shutter Back light compensa (BLC) Gamma compensa. system Built-in lens LTC 1132/xx LTC 1133/xx Video output Power source : : : : : : : : : : : : : Electrical (Color Version) Pick up device Num. [. . . ]