User manual PHILIPS LX600

[. . . ] DIGITAL A/V SURROUND RECEIVER LX600 Important notes for users in the U. K. Mains plug This apparatus is fitted with an approved 13 Amp plug. To change a fuse in this type of plug proceed as follows: Italia DICHIARAZIONE DI CONFORMITA' Si dichiara che l'apparecchio LX600 PHILIPS risponde alle prescrizioni dell'art. Fatto a Eindhoven Philips Consumer Electronics Philips, Glaslaan 2 5616 JB Eindhoven, The Netherlands 1 2 3 Remove fuse cover and fuse. Fix new fuse which should be a BS1362 5 Amp, A. S. T. A. [. . . ] ­ TUNER: starts automatic/manual preset programming. 5 SOURCE ­ Selects the relevant active source mode: DISC (6CH/COAX/OPTI), TUNER (FM/MW), AUX or TV. (on the remote only) ­ TV: switches to TV source mode. ­ DISC: toggles between DISC 6CH, DISC COAX and DISC OPTI source mode. ­ TUNER: toggles between FM and MW band. ­ AUX: selects AUX mode. 6 System display panel 7 SOUND ­ Selects a sound effect. 8 PHONES ­ Plug in the headphones jack. 9 VOLUME (VOL +-) ­ Adjusts the volume level. ­ Selects a setting in receiver setup menu. * = Press and hold the button for more than five seconds. 12 Functional Overview * 5 TV DISC TUNER AUX 012 ­ Use 1 2 to select a preset radio station. !SURROUND ­ Selects multichannel surround or stereo mode. @ SUBW +­ Adjusts subwoofer's sound level. REAR +­ Adjusts rear speakers' sound level. CENTER +­ Adjusts centre speaker's sound level. TV VOL +­ Adjusts TV volume (Philips TV only). DISC & DVD MENU SYSTEM VOL 9 0 3 0 3 STOP PLAY/PAUSE RESUME 7 ! SURROUND SOUND NIGHT MUTE # SLEEP ­ Sets the sleep timer function. REPEAT REPEAT SLEEP DIM ^ % $ # $ DIM ­ Selects different levels of brightness for display panel. @ SUBW REAR CENTER TV VOL % MUTE ­ Mutes or restores the volume. ^ NIGHT (in Dolby Digital mode only) ­ Optimises the dynamic of the sound output & Numeric Keypad (0-9) ­ Enters a number of a preset radio station. *B ­ Switches to standby mode. The following keys only operate on a Philips DVD player. For details, please refer to a Philips DVD player owner's manual ­ ­ ­ ­ ­ ­ ­ ­ ­ DVD MENU - DISC DVD MENU - SYSTEM 34 OK STOP PLAY/PAUSE RESUME REPEAT REPEAT A-B * = Press and hold the button for more than five seconds. 13 English Control buttons available on the remote only Getting Started Step 1: Inserting batteries into the remote control 3 1 2 Step 2: Switching on/off After completing all the connections, connect the AC power cord of the AV receiver to the wall outlet. Switching to an active mode G Press the SOURCE control to select : DISC 6CH TM DISC COAX TM DISC OPTI TM FM TM MWTM AUX TM TV TM DISC 6CH . . . . OR Press TV, DISC, TUNER or AUX on the remote. Switching to standby mode G Press STANDBY ON (B). The display screen will go blank. English 1 Open the battery compartment. 2 Insert two batteries type R06 or AA, following the indications (+-) inside the compartment. 3 Close the cover. Using the remote control to operate the system 1 Aim the remote control directly at the remote sensor (iR) on the front panel. SOUND Step 3: Setting the speakers TV DISC TUNER AUX 2 Select the source you wish to control by pressing one of the source select buttons on the remote control (for example TV, TUNER). You can adjust the delay times (centre and rear only) and volume level for individual speakers. These adjustments let you optimise the sound according to your surroundings and setup. [. . . ] Check that the batteries are loaded correctly. Place the AV receiver as far away as possible from electrical devices that may be causing interference. There is no sound from the centre and rear speakers. ­ ­ ­ ­ Radio reception is poor. ­ ­ ­ ­ The remote control does not function properly. ­ ­ ­ ­ ­ Low hum or buzz sound. ­ 19 Specifications AMPLIFIER SECTION Output power - Front - Rear - Centre - Subwoofer Frequency Response Signal-to-Noise Ratio Input Sensitivity - TV In - AUX In - 6 Channel In TUNER SECTION Tuning Range 100 W RMS / channel 100 W RMS / channel 100 W RMS 100 W RMS 150 Hz ­ 20 kHz / ­3 dB > 60 dB (CCIR) 500 mV 500 mV 800 mV MAIN UNIT Power Supply Rating Power Consumption Dimensions (w x h x d) Weight English 220 ­ 240 V; 50 Hz 180 W 435 mm x 54 mm x 388 mm 4. 16 kg SPEAKERS Front speakers / Rear (surround) speaker System 2-way, closed box system Impedance 3 Speaker drivers 18mm cone dome tweeter Frequency response 150 Hz ­ 20 kHz Dimensions (w x h x d) 93 mm x 174 mm x 65 mm Weight 0. 75 kg/each CENTRE SPEAKER System Impedance Speaker drivers Frequency response Dimensions (w x h x d) Weight FM 87. 5 ­ 108 MHz (50 kHz) MW 531 ­ 1602 kHz (9 kHz) 26 dB Quieting Sensitivity FM 22 dBf MW 5 µV/m Signal-to-Noise Ratio FM 55 dB MW 40 dB Harmonic Distortion FM Mono 3% FM Stereo 3% MW 5% Frequency Response FM 180 Hz ­ 10 kHz / ±6 dB Stereo Separation FM 26 dB (1 kHz) Stereo Threshold FM 23. 5 dB 2-way, closed box system 3 18mm cone dome tweeter, 150 Hz ­ 20 kHz 245 mm x 93 mm x 65 mm 1. 37 kg PASSIVE SUBWOOFER Frequency response 30 Hz ­ 150 Hz Dimensions (w x h x d) 156 mm x 350 mm x 350 mm Weight 4. 3 kg Specifications subject to change without prior notice 20 Glossary Analogue: Sound that has not been turned into numbers. [. . . ]