User manual PHILIPS M100D

[. . . ] Before starting the machine, carefully read the following instructions and always observe the safety norms contained herein. Do not use the machine if said instructions have not been carefully read!Warning The manufacturer declines any responsibility for damages, occurring as a result of: · improper use of the machine · Repairs not carried out by authorised personnel; · Use of non-genuine spare parts and accessories. How to use the instructions These instructions cannot anticipate every possible use of the machine. [. . . ] The counter shows the small coffee amount After a certain number of cycles, this function allows to stop the coffee dispensing (excluding hot water, steam and cappuccino dispensing operations). It can also be used, for example, to program the machine servicing. if the 0 value is set , the function is disabled. From the VENDING menu, move the asterisk to the COUNTER menu by means of keys and confirm the selection through ENT. Press the same keys to modify the selected value (for example to set a new servicing limit). On the contrary, by pressing ESC the new value entering is stopped and, as a result, the former counter setting shall be considered. When the set limit has been reached, the coffee dispensing stops and the following two messages are displayed: "COFFEE DISPENS. From time to time, empty the water tank. By using the keys move the asterisk to the menu item WASHING CYCLE. To enable this menu item use the ENT key. " As soon as the operating temperature has been reached, the following message is displayed: "SELECT PRODUCT "READY FOR USE " " On the contrary, should grinding be too fine, adjust it on a higher value (e. Place a cup under the steam/hot water spout (7) and fill it with water by operating the hot water knob. Preheating cups Cups may be preheated by placing them on the special cup heating plate. Temperature led When starting the machine, the following Grounds container warning light As soon as there are 30 grounds in the container, the following message is displayed: "DREGDRAWER FULL "READY FOR USE " " The machine does not stop: remove the grounds container and empty it. Grind adjustment If the coffee flows too quickly (coarse grind) or too slowly (fine grind) into the cup, adjust coffee grinder. the recommended grind level is position 5. Should grinding be too coarse, adjust it on a Important: before starting the rinsing cycle, always fill completely the water tank and put a capacious container (min. 1 litre) under the coffee dispensing unit, which is height-adjustable and can be removed for cleaning. Coffee quantity, according to the cup dimension. The desired quantity can be selected through the selection keys . the relevant messages will be displayed. To set the quantity of coffee to be dispensed, it is necessary to press the relevant selection key till the desired quantity of coffee is obtained (max. [. . . ] ) flow out of the steam/hot water dispensing tube in order to rinse away residues. Troubleshooting In case of failure, fault or suspected damage following a fall, unplug the machine immediately. To fix problems, follow the instructions in the table. otherwise contact authorised personnel. [. . . ]