User manual PHILIPS MC-100

[. . . ] Fix new fuse which should be a BS1362 5 Amp, A. If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. if the mains plug contains a fuse , this should have a value of 5 Amp. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5 Amp. [. . . ] When you recognise the passage you want, release PREV ¡1 or NEXT 2TM (on the remote control à or á ). Note: ­ During a disc programme or if SHUFFLE/ REPEAT active, searching is only possible within the same track. Insert a disc with the printed side facing up and press down on OPEN· cLOSE to close the CD door. READ is displayed as the CD player scans the contents of a disc, and then the total number of tracks and playing time are shown. Current track number and elapsed playing time of the track are displayed during disc playback. You can select and change the various play modes before or during playback. The play modes can also be combined with PROGRAMME. Tracks of the entire disc/ programme are played in random order SHUFFLE and REPEAT ALL. To repeat the entire disc/ programme continuously in random order REPEAT ALL . repeats the entire disc/ programme REPEAT . Plays the current track continuously If you like, store any track more than once. Use the PREV ¡1 or NEXT 2TM (on the remote control ¡ or TM) to select your desired track number. press PROGRAM to confirm the track number to be stored. The number of tracks programmed and total playing time of the programme is shown briefly, then the selected track and PROG. repeat steps 2-3 to select and store all desired tracks. FULL is displayed if you attempt to programme more than 20 tracks. To select your play mode, press the SHUFFLE or REPEAT button before or during playback until the display shows the desired function. If you have selected SHUFFLE, playback starts automatically. To return to normal playback, press the respective SHUFFLE or REPEAT button until the various SHUFFLE/ REPEAT modes are no longer displayed. In STOP mode, press and hold down PROGRAM for a while until the display shows all your stored track numbers in sequence. Q You can also press STOP 9 to cancel your play mode. You can erase the programme by: q pressing STOP 9 once in the STOP mode; q pressing STOP 9 twice during playback; q opening the CD compartment; PROGRAM disappears from the display. [. . . ] Q To protect a tape from accidental erasure, have the tape in front of you and break out the left tab. Recording on this side is no longer possible. If, however, you wish to record over this side again, cover the tabs with a piece of adhesive tape. Insert a suitable tape into the deck and close the tape door. [. . . ]