User manual PHILIPS MC-128

[. . . ] Note: The severed plug must be disposed of to avoid a possible shock hazard should it be inserted into a 13 Amp socket elsewhere. How to connect a plug The wires in the mains lead are coloured with the following code: blue = neutral (N), brown = live (L). ¶ As these colours may not correspond with the colour markings identifying the terminals in your plug, proceed as follows: ­ Connect the blue wire to the terminal marked N or coloured black. Connect the brown wire to the terminal marked L or coloured red. [. . . ] Q Press PREV ¡1 or NEXT 2TM (on the remote control ¡ or TM) once or repeatedly until the desired track number appears in the display. Q If you have selected a track number shortly after loading a disc or in the PAUSE position, you will need to press PLAY· This CD player plays Audio Discs including CDRecordables and CD-Rewritables. Q CD-ROM, CD-I, CDV, VCD, DVD or computer CDs, however, are not possible. Finding a passage within a track 1 press and hold down on PREV ¡1 or NEXT 2TM (on the remote control à or á ). The disc is played at high speed and low volume. When you recognise the passage you want, release PREV ¡1 or NEXT 2TM (on the remote control à or á ). Note: ­ During a disc programme or if SHUFFLE/ REPEAT active, searching is only possible within the same track. Insert a disc with the printed side facing up and press down on OPEN· cLOSE to close the CD door. READ is displayed as the CD player scans the contents of a disc, and then the total number of tracks and playing time are shown. Current track number and elapsed playing time of the track are displayed during disc playback. You can select and change the various play modes before or during playback. Repeat step 3 if necessary until you find the desired station. Press PROGRAM for more than 2 seconds to activate programming. AUTO is displayed and available stations are programmed in order of waveband reception strength: FM followed by MW and LW. Press PRESET 4 or 3 (on the remote control ¡ or TM ) to allocate a number from 1 to 40 to this station. press PROGRAM again to confirm the setting. PROGRAM disappears, the preset number and the frequency of the preset station are shown. Repeat the above four steps to store other stations. Q To tune to a weak station, press TUNING à or á briefly and repeatedly until you have found optimal reception. Q You can override a preset station by storing another frequency in its place. Enhanced Other Network allows you to search for an RDS station offering a certain programme type. If you are receiving a RDS station, and the station name are displayed. [. . . ] When you recognise the passage you want, release PREV ¡1 or NEXT 2TM. Recording will begin from this exact point in the track when you press RECORD. Q The keys are automatically released at the end of the tape, except if PAUSE has been activated. Note: ­ The sound source cannot be changed while recording a tape. [. . . ]