User manual PHILIPS MC-200-21M

[. . . ] Fix new fuse which should be a BS1362 5 Amp, A. If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. if the mains plug contains a fuse , this should have a value of 5 Amp. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5 Amp. [. . . ] Current track number and elapsed playing time of the track are displayed during disc playback. You can select and change the various play modes before or during playback. The play modes can also be combined with PROGRAMME. Tracks of the entire disc/ programme are played in random order SHUFFLE and REPEAT ALL. To repeat the entire disc/ programme continuously in random order REPEAT ALL . repeats the entire disc/ programme REPEAT . Plays the current track continuously If you like, store any track more than once. Use the PREV ¡1 or NEXT 2TM (on the remote control ¡ or TM) to select your desired track number. press PROGRAM to confirm the track number to be stored. The number of tracks programmed and total playing time of the programme is shown briefly, then the selected track and PROG. repeat steps 2-3 to select and store all desired tracks. FULL is displayed if you attempt to programme more than 20 tracks. To select your play mode, press the SHUFFLE or REPEAT button before or during playback until the display shows the desired function. If you have selected SHUFFLE, playback starts automatically. To return to normal playback, press the respective SHUFFLE or REPEAT button until the various SHUFFLE/ REPEAT modes are no longer displayed. In STOP mode, press and hold down PROGRAM for a while until the display shows all your stored track numbers in sequence. Q You can also press STOP 9 to cancel your play mode. You can erase the programme by: q pressing STOP 9 once in the STOP mode; q pressing STOP 9 twice during playback; q opening the CD compartment; PROGRAM disappears from the display. From this preset number upwards, former programmed radio stations will be overridden. The system will only programme stations which are not in the memory already. Press PRESET 4 or 3 (on the remote control ¡ or TM ) to select the preset number where programming should start. Note: ­ If no preset number is selected, default is preset (1) and all your presets will be overridden. [. . . ] Note: ­ The sound source cannot be changed while recording a tape. Insert a suitable tape into the deck and close the tape door. To record from the radio, you will need to use a preset radio station and to set a start (ON) and finish (OFF) time. Press SELECT SOURCE repeatedly, or turn VOLUME clockwise until REC TUN source is displayed. [. . . ]