User manual PHILIPS MC-222

[. . . ] Micro Hi-Fi System Audio MC-220 MC-222 1 Important notes for users in the U. K. Mains plug This apparatus is fitted with an approved 13 Amp plug. To change a fuse in this type of plug proceed as follows: Italia DICHIARAZIONE DI CONFORMITA' Si dichiara che l'apparecchio MC-220, MC-222 Philips risponde alle prescrizioni dell'art. Fatto a Eindhoven Philips Consumer Electronics Philips, Glaslaan 2 5616 JB Eindhoven, The Netherlands 1 2 3 Remove fuse cover and fuse. Fix new fuse which should be a BS1362 5 Amp, A. S. T. A. [. . . ] Press BAND once or more to select your waveband. Press down on TUNING à or á and release button. The radio automatically tunes to a station with sufficient reception. Display indication during automatic tuning: SEARCH. If a FM station is received in stereo, STEREO is shown. Repeat step 3 if necessary until you find the desired station. 2 Press PROGRAM for more than 2 seconds to activate programming. AUTO is displayed and available stations are programmed in order of waveband reception strength: FM followed by MW and LW. The last preset automatically stored will then be played. Manual programming 1 2 3 4 Tune to your desired station (see "Tuning to radio stations"). Press PRESET 3 or 4 (on the remote control ¡ or TM ) to allocate a number from 1 to 40 to this station. Press PROGRAM again to confirm the setting. PROGRAM disappears, the preset number and the frequency of the preset station are shown. Repeat the above four steps to store other stations. G To tune to a weak station, press TUNING à or á briefly and repeatedly until you have found optimal reception. 4 5 G You can override a preset station by storing another frequency in its place. 14 Radio Reception Tuning to preset radio stations G Press PRESET 3 or 4 (on the remote control ¡ or TM ) until the desired preset station is displayed. Searching programme type (PTY) PTY helps you find a desired programme type. To enable PTY, first programme RDS stations into the tuner memory (see "Programming radio stations") RDS Radio Data System is a service that allows FM stations to show additional information. If you are receiving a RDS station, and the station name are displayed. When automatic programming is used, RDS stations will be programmed first. Scrolling through different RDS information G Press RDS briefly and repeatedly to scroll through the following information (if available): ­ Station name ­ Programme type such as NEWS, SPORT, POP M . . . ­ Radio text messages ­ Frequency Note: ­ If you press RDS and the RDS signal is not available NO RDS is displayed. 1 2 While receiving an RDS station, press RDS briefly until the programme type is displayed. Press PRESET 3 or 4 (on the remote control ¡ or TM ) until the desired programme type is displayed. Press and hold down on TUNING à or á (on the remote control à or á ) to start searching. The radio tunes to a RDS station broadcasting this programme type. If the programme type is not available TYPE NOT FOUND is displayed. [. . . ] If you are unable to remedy a problem by following these hints, consult your dealer or service centre. Problem CD OPERATION "NO DISC" is displayed. Solution ­ Insert a disc. ­ Check if the disc is inserted upside down. ­ Wait until the moisture condensation at the lens has cleared. ­ Replace or clean the disc, see "Maintenance". [. . . ]