User manual PHILIPS MC-320

[. . . ] Fix new fuse which should be a BS1362 5 Amp, A. If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. if the mains plug contains a fuse , this should have a value of 5 Amp. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5 Amp. [. . . ] Playback will continue without sound and the display shows MUTE. G To activate sound reproduction you can: ­ press MUTE again; ­ adjust the volume controls; ­ change source. The lens of the CD player should never be touched. Current track number and elapsed playing time of the track are displayed during disc playback. ­ you select another source:TAPE, TUNER or AUX. ­ Track number and elapsed play time of current track ­ Track number and remaining play time of current track ­ Track number and total elapsed play time of the disc ­ Total remaining number of tracks and total remaining time. cD SHUFFLE and REPEAT playback mode G Press DISPLAY repeatedly , following information will be displayed consecutively. ­ Track number and elapsed play time of current track ­ Track number and remaining play time of current track CD PROGRAM playback mode G Press DISPLAY repeatedly, following information will be displayed consecutively ­ Track number and elapsed play time of current track ­ Track number and remaining play time of current track ­ Current program number and track number G CD-ROM, CD-I, CDV, VCD, MP3, DVD or computer CDs, however, are not possible. Put a disc with the printed side facing up and press down. READING is displayed as the CD player scans the contents of a disc, and then the total number of tracks and playing time are shown. G Press or once or repeatedly until the desired track number appears in the display. G If you have selected a track number shortly after loading a disc or in the PAUSE position, you will need to press to start playback. If you like, store any track more than once. Finding a passage within a track 1 2 Press and hold down on or The disc is played at high speed and low volume. When you recognise the passage you want, release or . Note: ­ During a disc programme or if SHUFFLE/ REPEAT active, searching is only possible within the same track. To select your desired track MEMORY FULL is displayed if you attempt to program more than 40 tracks. To start playback of your disc program, press STOP 9 followed by or press directly. You can select and change the various play modes before or during playback. The REPEAT modes can also be combined with PROGRAM. Tracks of the entire disc are played in random order SHUFFLE and REPEAT ALL. To repeat the entire disc continuously in random order REPEAT ALL . [. . . ] REPEAT A AND B : both sides are played repeatedly, up to 5 times each side. G Recording is permissible insofar as copyright or other rights of third parties are not infringed. G For recording, use only NORMAL (IEC type I) tapes on which the tabs have not yet been broken. This deck is not suited for recording on METAL (IEC IV) type tapes. [. . . ]