User manual PHILIPS MC-77

[. . . ] Micro Hi-Fi System MC-77 MC-77 1 3103 306 18501 pg 001-030/MC77/22-Eng 1 1/31/02, 7:55 PM Important notes for users in the U. K. Mains plug This apparatus is fitted with an approved 13 Amp plug. To change a fuse in this type of plug proceed as follows: Italia DICHIARAZIONE DI CONFORMITA' Si dichiara che l'apparecchio MC-77 Philips risponde alle prescrizioni dell'art. Fatto a Eindhoven Philips Consumer Electronics Philips, Glaslaan 2 5616 JB Eindhoven, The Netherlands 1 2 3 Remove fuse cover and fuse. Fix new fuse which should be a BS1362 5 Amp, A. S. T. A. [. . . ] "ALL DISC" or "PROGRAM" ­ to repeat playback of all available discs or programmed tracks. To resume normal playback, press REPEAT until "OFF" is displayed. REPEAT is shown, except for REPEAT OFF mode. 2 17 3103 306 18501 pg 001-030/MC77/22-Eng 17 1/31/02, 7:56 PM English CD Operation English Random play 1 Press SHUFFLE on the remote control. SHUFFLE is shown and "SHUFFLE" is displayed. All the available discs or programmed tracks (if programme is active) will be played in random order. To resume normal playback, press SHUFFLE again. Notes: ­ Selecting SHUFFLE during repeat playback will cancel all repeat modes. ­ Pressing the CD OPEN·CLOSE button will cancel all repeat and shuffling modes. 2 Notes: ­ If the total playing time is more than "99:59" or if one of the programmed tracks has a number greater than 30, then "--:--" is displayed instead of the total playing time. ­ If you attempt to programme more than 40 tracks, "PROGRAM FULL" is displayed. ­ If you press any of the CD DIRECT 1/2/3 buttons on the remote control, the system will play the selected disc or track, and the stored programme will be ignored temporarily. The PROGRAM symbol also will disappear temporarily from the display. It will reappear when playback of the selected disc ends. ­ During programming, if no key is pressed within 20 seconds, the system will exit the programme mode automatically. To review the programme q Stop playback and press í or ë repeatedly. q To exit review mode, press Ç. Programming the disc tracks Programming tracks is possible when playback is stopped. Up to 40 tracks can be stored in the memory in any order. 1 2 3 4 5 Load the desired discs on the disc trays (refer to "Loading Disc"). Press CD 1·2·3 or CD DIRECT 1/2/3 button to select a disc. Press í or ë repeatedly to select the desired track. Press PROG to store the track. Erasing the programme q Press Ç once when playback is stopped or twice during playback. PROGRAM disappears and "PROGRAM CLEARED" is displayed. Note: ­ The programme will be erased when the system is disconnected from the power supply or when the disc tray is opened. q Repeat steps 3­5 to store other discs and tracks. 6 To end programming, press Ç once. PROGRAM stays and the programme mode remains active. [. . . ] ­ Check if the disc is inserted upside down. ­ Wait until the moisture condensation at the lens has cleared. ­ Replace or clean the disc, see "Maintenance". ­ Use a finalised CD-RW or CD-R. "DISC NOT FINALIZED" is displayed. [. . . ]