User manual PHILIPS MC-M250

[. . . ] Micro Hi-Fi System MC-M250 1 3140 115 29251 pg 001-021/M250/22-Eng 1 4/17/02, 4:59 PM Important notes for users in the U. K. Mains plug This apparatus is fitted with an approved 13 Amp plug. To change a fuse in this type of plug proceed as follows: Italia DICHIARAZIONE DI CONFORMITA' Si dichiara che l'apparecchio MC-M250 Philips risponde alle prescrizioni dell'art. Fatto a Eindhoven Philips Consumer Electronics Philips, Glaslaan 2 5616 JB Eindhoven, The Netherlands 1 2 3 Remove fuse cover and fuse. Fix new fuse which should be a BS1362 5 Amp, A. S. T. A. [. . . ] A track number is shown and prog flashes. Press S or T (¡ or TM) repeatedly to select your desired track number. 2 q For MP3 disc, press 4 / 3 and S / T (¡ or TM) to select the desired album and track for programming. 3 Selecting a desired album/track (MP3 disc only) To select a desired album q Press 4 or 3 repeatedly. To select a desired track q Press S or T (¡ or TM) repeatedly. Press PROGRAM to confirm the track number to be stored. The number of tracks programmed and total playing time of the programme is shown briefly, then the selected track and "PROG PROG". PROG For MP3 disc, total playing time will not be shown. Repeat steps 2-3 to select and store all desired tracks. MEMORY FULL" "MEMORY FULL is displayed if you attempt to programme more than 20 tracks. To start playback of your disc programme, press ÉÅ. Note: ­ It is not possible to create a programme with MP3 tracks from multiple CDs, or combined with normal audio tracks. 4 Different play modes: SHUFFLE and REPEAT You can select and change the various play modes before or during playback. 5 1 Press MODE on the remote control to select : shuffle ­ tracks of the entire disc/ programme are played in random order. shuffle repeat all ­ to repeat the entire disc/ programme continuously in random order. repeat all ­ to repeat the entire disc/ programme. repeat ­ to repeat the current track. To return to normal playback, press MODE until the various SHUFFLE/ REPEAT modes are no longer displayed. Reviewing the programme In stop mode, press and hold PROGRAM until the display shows all your stored track numbers in sequence. 2 q You can also press 9 to cancel your play mode. Note: ­ If Shuffle is activated on a MP3-CD, all titles stored in the disc will be played in random order. Erasing the programme q Press Ç once when playback is stopped or twice during playback. prog disappears and "CLEAR is displayed. CLEAR" CLEAR Note: ­ The programme will be erased when the system is disconnected from the power supply or when the disc tray is opened. 13 3140 115 29252 pg 001-021/M250/22-Eng 13 4/17/02, 5:00 PM English Radio Reception English STA ND BY Programming radio stations N -O You can store up to a total of 40 radio stations in the memory. Automatic programming Automatic programming will start with a chosen preset number. From this preset number upwards, former programmed radio stations will be overridden. The system will only programme stations which are not in the memory already. iR SOURCE TIMER SET CLOCK·RDS BAND + MP3·ALBUM VOLUME REC DISPLAY PROGRAM PRESET TRACK·SEARCH·TUNE 1 Press 4 or 3 to select the preset number where programming should start. Note: ­ If no preset number is selected, default is preset (1) and all your presets will be overridden. Tuning to radio stations 1 2 3 Select TUNER source. TUNER" TUNER Press BAND to select the desired waveband : FM, MW or LW. Press down on S or T (à or á) and release button. [. . . ] ­ Wait until the moisture condensation at the lens has cleared. ­ Replace or clean the disc, see "Maintenance". ­ Use a finalised CD-RW or CD-R. 20 3140 115 29252 pg 001-021/M250/22-Eng 20 4/17/02, 5:00 PM Troubleshooting RADIO RECEPTION Radio reception is poor. ­ If the signal is too weak, adjust the antenna or connect an external antenna for better reception. [. . . ]