User manual PHILIPS MC-M250-21M

[. . . ] Micro Hi-Fi System MC-M250 1 3140 115 29261 pg 001-020/M250/21-Eng 1 4/16/02, 7:03 PM México Es necesario que lea cuidadosamente su instructivo de manejo. PRECAUCIÓN - ADVERTENCIA No abrir, riesgo de choque eléctrico ATENCIÓN Verifique que el voltaje de alimentación sea el requerido para su aparato Para evitar el riesgo de choque eléctrico, no quite la tapa. En caso de requerir servicio, dirijase al personal calificado. Microsistema de Audio MC-M250/21 110­127 / 220­240V; ~50­60 Hz 26 W Philips Mexicana, S. A. Industrial Vallejo Localidad y Tel: C. P. 5728-4200 Exportador: Philips Electronics HK, Ltd. [. . . ] Repeat steps 2-3 to select and store all desired tracks. MEMORY FULL" "MEMORY FULL is displayed if you attempt to programme more than 20 tracks. To start playback of your disc programme, press ÉÅ. Note: ­ It is not possible to create a programme with MP3 tracks from multiple CDs, or combined with normal audio tracks. 4 Different play modes: SHUFFLE and REPEAT You can select and change the various play modes before or during playback. 5 1 Press MODE on the remote control to select : shuffle ­ tracks of the entire disc/ programme are played in random order. shuffle repeat all ­ to repeat the entire disc/ programme continuously in random order. repeat all ­ to repeat the entire disc/ programme. repeat ­ to repeat the current track. To return to normal playback, press MODE until the various SHUFFLE/ REPEAT modes are no longer displayed. Reviewing the programme In stop mode, press and hold PROGRAM until the display shows all your stored track numbers in sequence. 2 q You can also press 9 to cancel your play mode. Note: ­ If Shuffle is activated on a MP3-CD, all titles stored in the disc will be played in random order. Erasing the programme q Press Ç once when playback is stopped or twice during playback. prog disappears and "CLEAR is displayed. CLEAR" CLEAR Note: ­ The programme will be erased when the system is disconnected from the power supply or when the disc tray is opened. 13 3140 115 29261 pg 001-020/M250/21-Eng 13 4/16/02, 7:05 PM English Finding a passage within a track Programming the disc tracks Radio Reception Note: ­ If no preset number is selected, default is preset (1) and all your presets will be overridden. STA ND BY English N -O 2 iR SOURCE TIMER SET CLOCK BAND + MP3·ALBUM VOLUME REC Press PROGRAM for more than two seconds to activate programming. "AUTO is displayed and available stations are AUTO" AUTO programmed in order of waveband reception strength: FM followed by MW. The last preset automatically stored will then be played. Manual programming DISPLAY PROGRAM PRESET TRACK·SEARCH·TUNE 1 2 3 4 5 Tune to your desired station (refer to "Tuning to radio stations"). Press 4 or 3 to allocate a number from 1 to 40 to this station. Press PROGRAM again to confirm the setting. prog disappears, the preset number and the frequency of the preset station are shown. Repeat the above four steps to store other stations. Tuning to radio stations 1 2 3 Select TUNER source. TUNER" TUNER Press BAND to select the desired waveband : FM or MW. Press down on S or T (à or á) and release button. The display will show "SEARCH until a radio SEARCH" SEARCH station with sufficient signal strength is found. If a FM station is received in stereo, is shown. [. . . ] ­ Check if the disc is inserted upside down. ­ Wait until the moisture condensation at the lens has cleared. ­ Replace or clean the disc, see "Maintenance". ­ Use a finalised CD-RW or CD-R. 19 3140 115 29261 pg 001-020/M250/21-Eng 19 4/16/02, 7:05 PM English Troubleshooting RADIO RECEPTION Radio reception is poor. English 20 ­ If the signal is too weak, adjust the antenna or connect an external antenna for better reception. [. . . ]