User manual PHILIPS MC147

[. . . ] Micro Hi-Fi System Register your product and get support at MC147 www. philips. com/welcome User manual CAUTION Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. 2 1 3 $ # ^ % ¡ & * 9 5 0 ( ) ! PULL TO OPEN 4 1 STANDBY-ON M I C RO S Y S T E M M C 1 4 7 2 3 4 5 iR CD/CD-R/CD-RW COMPATIBLE 6 7 8 9 0 SOURCE VOL TUNING PRESET REPEAT PROG VOL DBB PULL TO OPEN @ 3 Contents English 4 General Information Supplied accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Environmental Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Hearing Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Manual programming Tuning to radio stations 1 2 Press SOURCE on the set repeatedly or press TUN on the remote control repeatedly until the desired waveband (FM or MW) is displayed. Press down on TUNING 4 ¢ (à / á on the remote control) and release the button. The radio automatically tunes to a station with sufficient reception. Display indication during automatic tuning: SrcH. Repeat step 2 if necessary until you find the desired station. 1 2 3 4 5 Tune to your desired station (see Tuning to radio stations). Press PRESET +/- to allocate a number from 1 to 40 to this station. Press PROG again to confirm the setting. PROG disappears, the preset number and the frequency of the preset station are shown. Repeat the above four steps to store other stations. 3 To tune to a weak station, press TUNING 4 ¢ (à / á on the remote control) briefly and repeatedly until you have found optimal reception. You can override a preset station by storing another frequency in its place. Tuning to preset radio stations Press PRESET +/- until the desired preset station is displayed. Programming radio stations You can store up to a total of 40 radio stations in the memory. Automatic programming Automatic programming will start with a chosen preset number. From this preset number upwards, former programmed radio stations will be overridden. The system will only programme stations which are not in the memory already. 13 English Tape Operation / Recording English PULL TO OPEN The best recording level is set automatically. Altering the VOLUME or DBB controls will not affect the recording in progress. The recording sound quality might differ depending on the quality of your recording source and the recording tape. At the very beginning and end of the tape, no recording will take place during the 7 seconds when the leader tape passes the recorder heads. To protect a tape from accidental erasure, have the tape in front of you and break out the left tab. Recording on this side is no longer possible. If, however, you wish to record over this side again, cover the tabs with a piece of adhesive tape. Tape playback 1 2 3 4 5 6 7 8 Select TAPE source. Display: shows "tAPE" throughout tape operation. Open the tape key flap marked "PULL TO OPEN" on the front panel. Press STOP·OPENÇ0 to open the tape door. Synchro start CD recording 1 2 3 4 5 Select CD source. Insert a disc and if desired, programme track numbers. [. . . ] Philips may, at its discretion choose to replace rather than repair any product covered by this warranty. Product accessories are covered by the same warranty period. Please contact the Philips Technology 2. 3. Authorised Service Centre Network 1300 361 392 Customer support is provided in Australia by our trained call centre staff. [. . . ]