User manual PHILIPS MC170

[. . . ] Repeats a track, the entire CD or the program SHUFFLE . cD: skips forward RADIO: selects a preset radio station STOP 9. Stops CD play and erases the program Remove batteries if they are flat or the set is not going to be used for a long time. 1 Check whether the mains voltage as shown on the type plate corresponds to your local mains voltage. [. . . ] We have done our utmost to make the packaging easily separable into three mono materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet). Your set consists of materials which can be recycled if disassembled by a specialized company. The sleeptimer is a set period of time before the set switches off. The clock time has to be set before the sleeptimer can be used. 1 Press SLEEP on the remote control until the desired sleeper time is displayed. © SLEEP, 60, 45, 30, 15, 10, OFF 2 As soon as the desired time is displayed, do not press the key again. It is possible to set the clock by using a time signal which is broadcast with RDS stations. This only works if the RDS station is sending this signal. The set can be used as an alarm clock, whereby the CD or tuner is switched on at a set time. Note: The time signal broadcasted from certain RDS stations may not always be accurate. If you find there is a discrepancy in clock time, set your clock manually (and the time will then run accurately). Always keep the tray closed to avoid dust on the lens. The lens may cloud over when the set is suddenly moved from cold to warm surroundings. Leave the CD-player in a warm environment until the moisture evaporates. To take the CD out of its box easily, press the centre spindle while lifting the CD. Always pick up the CD by the edge and put it back in its box after use. To clean the CD, wipe it in a straight line from the centre toward the edge using a soft, lintfree cloth. 2 To review your program keep PROGRAM depressed for more than 2 seconds. Note: If you try to store more than 20 tracks the display shows PROGRAM FULL. You can select up to 20 tracks and store them in the memory in a desired sequence. © PROGRAM CLEARED is displayed once, PROGRAM goes off and the program is erased. Note: The program will also be erased if you ­ interrupt the power supply, ­ open the CD tray. [. . . ] Do not open the set as there is a risk of electric shock. If a fault occurs, first check the points listed, before taking the set for repair. If you are unable to solve a problem by following these hints, consult your dealer or service center. No sound, no power No reaction to controls Poor radio reception NO DISC indication CD-RW (CD-R) is not properly recorded for the use on a standard CD player. [. . . ]