User manual PHILIPS MCB204

[. . . ] Micro Hi-Fi System MCB204 User manual Important notes for users in the U. K. Mains plug This apparatus is fitted with an approved 13 Amp plug. To change a fuse in this type of plug proceed as follows: 1 2 3 Remove fuse cover and fuse. Fix new fuse which should be a BS1362 3 Amp, A. S. T. A. If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. [. . . ] If you press 9 during scanning, the scanning process will stop and the system will return to the DAB frequency before scanning starts. The other DAB operation buttons will be locked. Note: ­ If no DAB service is detected during the above processes, the display panel will show "NO SERVICE". Manual tuning 1 Press and hold ENTER/ÉÅ for more than 2 seconds to start manual tuning. The current DAB channel and frequency will be displayed. Press S/T on the front panel or press 5 / 6 on the remote control to select your desired DAB channels. Press ENTER/ÉÅ to confirm and tune to your selected channel. Tuning to DAB for the first time 1 Press SOURCE on the system to select DAB (or press DAB/FM on the remote control). The system will start full scan to search for all available Band III channels automatically. If no DAB service is available, "NO SERVICE" will appear on the display panel. If there are available DAB services, the system will store all detected stations. 2 Re-tuning By re-tuning, you can update your DAB multiplex (ensemble) list all over again. At the completion of scanning, the system will tune to the first service of the first multiplex (ensemble) in the updated multiplex (ensemble) list. 14 DAB Reception DAB information display You can view the DAB service information in the following 6 information modes. Depending on the DAB radio station you are tuning to, some information modes may be unavailable. Programming DAB stations You can save up to 20 DAB stations in the system memory. 1 Press INFO. /RDS repeatedly to view the following information. ­ DLS ­ ERR ­ NEWS/SPORT/STA ­ bps ­ time ­ station (12B 225. 64 MHz) Press PROGRAM on the front panel or press PROG on the remote control. The display shows "PN", where N stands for the preset number. Press S/T on the front panel or press ¡ / TM on the remote control 0to select your desired preset number. Press PROGRAM on the front panel or press PROG on the remote control to confirm the selected station to be stored. The display shows "PN SAVED" briefly, indicating the preset is saved. Note: ­ If no service is associated with the number you input, the display will show "PN EMP" briefly, where "N" stands for the input preset number. 2 3 4 Repeat steps 2-3 to select and store all desired Tuning to preset DAB stations Press S/T on the front panel or press ¡ / TM on the remote control repeatedly until the desired preset station is displayed. 15 English FM Radio Reception English AUTO is displayed and available stations are programmed. The first preset automatically stored will then be played. Manual programming 1 2 3 Tuning to radio stations 1 2 Press SOURCE on the set repeatedly or press DAB/FM on the remote repeatedly to select TUNER source. Press down on TUNING 4 ¢ (or 5/6 on the remote control) and release the button. The display will show "SEARCH" until a radio station with sufficient signal strength is found. Tune to your desired station (see Tuning to radio stations). [. . . ] If a fault occurs, first check the points listed below before taking the system for repair. If you are unable to remedy a problem by following these hints, consult your dealer or Philips for help. Problem "NO DISC" is displayed. Check if the disc is inserted upside down. [. . . ]