User manual PHILIPS MCD289

[. . . ] DVD Micro Theatre Register your product and get support at MCD289 www. philips. com/welcome User manual Manuel d'utilisation Manual del usuario Benutzerhandücher Gebruikershandleidingen Manuale per l'utente Användarhandböckerna Brugermanual Important notes for users in the U. K. Mains plug This apparatus is fitted with an approved 13 Amp plug. To change a fuse in this type of plug proceed as follows: Italia DICHIARAZIONE DI CONFORMITA' Si dichiara che l'apparecchio MCD289 Philips risponde alle prescrizioni dell'art. Fatto a Eindhoven Philips Consumer Electronics Philips, Glaslaan 2 5616 JB Eindhoven, The Netherlands 1 2 3 Remove fuse cover and fuse. Fix new fuse which should be a BS1362 3 Amp, A. S. T. A. [. . . ] Press 2/3/5/4 on the remote control to toggle through the functions and select your preferential option. Move to one of the following and press 3. 1 2 Aim the Remote Control directly at the remote sensor (IR) on the front panel. Do not put any objects between the Remote Control and the DVD Player while operating the DVD Player. ­ Setting TV TYPE Allows you to select the colour system matching the connected TV set. The options include "PAL" (Wide screen mode), "MULTI" and "NTSC". Note: The format you select must be available on the disc. If it is not, the setting for TV Type will not affect the picture during playback. To exit the menu Press SYSTEM MENU again. Setting up Progressive Scan feature (for Progressive Scan TV only) Step 2: Setting the clock 1 2 3 4 5 6 Go to Standby mode. Press and hold CLOCK on the remote control. "CLOCK SET" is displayed briefly. Then, the hour digits flash on the display screen. Press VOLUME -/+ (VOL +/- on the remote control) to set the hours. The minute digits flash on the display screen. Press VOLUME -/+ (VOL +/- on the remote control) to set the minutes. Press CLOCK to confirm the clock setting. Notes: ­ This system only supports 24-hour mode. ­ The clock setting will be erased when the system is disconnected from the power supply. ­ The system will exit clock setting mode if no button is pressed within 30 seconds. 1 2 3 4 5 6 Turn on your TV. Turn off your TV progressive scan mode or turn on interlaced mode (refer to your TV user manual). Press ECO POWER/STANDBY-ON B (STANDBY-ON B on the remote control) to turn on the DVD player. The DVD background screen appears on the TV. Press 2/3 repeatedly to select "VIDEO SETUP PAGE". 17 English Preparations English 7 Select "TV MODE" to "P-SCAN", then OK to confirm. [. . . ] 2) Press SYSTEM MENU on the remote control to exit the system menu and then DISC and 1 to exit progressive scan. Distorted or poor picture. Sometimes a slight picture distor tion may appear. This is not a malfunction. Clean the disc. The aspect ratio of the screen cannot be changed even though you have set the TV shape. The aspect ratio is fixed on the DVD disc. The aspect ratio may not be changed for some TV systems. 29 English Troubleshooting English 30 Problem The DVD player does not start playback. Check the disc type, color system and region code. Clean the disc. Place the disc with the playback side down. [. . . ]