User manual PHILIPS MCM204

[. . . ] Micro Hi-Fi System MCM204 User manual Manuel d'utilisation Manual del usuario Benutzerhandücher Gebruikershandleidingen Manuale per l'utente Användarhandböckerna Brugermanual Käyttöoppaita Manual do usuário Important notes for users in the U. K. Mains plug This apparatus is fitted with an approved 13 Amp plug. To change a fuse in this type of plug proceed as follows: Italia DICHIARAZIONE DI CONFORMITA' Si dichiara che l'apparecchio MCM204 Philips risponde alle prescrizioni dell'art. Fatto a Eindhoven Philips Consumer Electronics Philips, Glaslaan 2 5616 JB Eindhoven, The Netherlands 1 2 3 Remove fuse cover and fuse. Fix new fuse which should be a BS1362 3 Amp, A. S. T. A. [. . . ] ­ you press the tape deck PLAY 2 key. 1 2 Select CD source. Press OPEN/CLOSE3 on the top of the system to open the CD compartment. OPEN is displayed when you open the CD compartment. Insert a disc with the printed side facing up and press down on OPEN/CLOSE3 to close the CD door. READING is displayed as the CD player scans the contents of a disc, and then the total number of tracks and playing time (or the total number of albums and tracks for MP3 disc) are shown. 3 Playing an MP3 disc 1 Load an MP3 disc. The disc reading time may exceed 10 seconds due to the large number of songs compiled into one disc. YY is the total album number and XXX is the total track number. Press ALBUM/PRESET 4 3 (or 4 3 on the remote control) to select a desired album. 2 Basic playback controls To play a disc Press 2; to start playback. 13 English CD/MP3 Operation English 3 Press TUNING 4 ¢ (on the remote control 4 ¢) to select a desired track. The album number will change accordingly as you reach the first track of an album by pressing 4 or the last track of an album by pressing ¢. Press 2; to start playback. Note: ­ The SHUFFLE and REPEAT functions cannot be used simultaneously. Programming track numbers Programme in the STOP position to select and store your disc tracks in the desired sequence. If you like, store any track more than once. Up to 40 tracks can be stored in the memory. 4 During playback, press DISPLAY/CLOCK to show the album and track numbers. Supported MP3 disc formats: ­ ISO9660, Joliet, UDF 1. 5 ­ Maximum title number: 256 (depending on filename length) ­ Maximum album number: 99 ­ Supported sampling frequencies: 32 kHz, 44. 1 kHz, 48 kHz ­ Supported Bit-rates: 32~256 (kbps), variable bitrates 1 In the stop position, use the TUNING 4 ¢ (on the remote control 4 ¢) to select your desired track number. For MP3, you may press ALBUM/PRESET 4 3 to select a desired album, then press ¡1 2TM to select your desired track. 2 Different play modes: SHUFFLE and REPEAT You can select and change the various play modes before or during playback. The play modes can also be combined with PROGRAMME. tracks of the entire disc are played in random order REP ALL . . . . . . . . . . . repeats the entire disc/ programme REP . . . . . . . . . . . . . . . . . . . plays the current track continuously REP ALB . . . . . . . . . . . repeats all tracks in the current (for MP3 only) album 3 Press PROG to store. Display: PROG flashes, and PR 01 is displayed briefly, then the selected track number (and the selected album number for MP3). Repeat steps 1-2 to select and store all desired tracks. [. . . ] Problem "NO DISC" is displayed. Check if the disc is inserted upside down. Wait until the moisture condensation at the lens has cleared. Replace or clean the disc, see "Maintenance". Use a finalized CD-RW or a correct MP3-CD format disc. [. . . ]