User manual PHILIPS MCM7000

[. . . ] Register your product and get support at www. philips. com/welcome MCM7000 EN User manual FR Mode d'emploi ES Manual del usuario DE Benutzerhandbuch 3 21 41 61 NL Gebruiksaanwijzing IT Manuale utente 81 101 121 141 PT Manual do utilizador SV Användarhandbok (in standby mode) (in standby mode) Contents 1 Important Safety Notice 4 4 6 7 7 7 8 10 10 11 11 11 12 12 12 12 12 12 13 13 13 13 14 14 14 14 15 15 15 15 6 Other features Set alarm timer Set the sleep timer Listen to external audio device Listen through headphone 2 Your Micro Hi-Fi System Introduction What's in the box Product overview 16 16 16 16 16 17 17 18 18 18 7 Product information Specifications USB playability information Supported MP3 disc formats 3 Get started Connect speakers Connect FM antenna Connect power Prepare the remote control Set clock Demonstrate the unit's features Adjust brightness of display panel Turn on or off LED light Turn on Switch to standby mode 8 Troubleshooting 4 Play Basic play operations Play from disc Play from USB Adjust sound 5 Listen to FM radio Plug and play installation Tune to FM radio stations Program radio stations automatically Program radio stations manually Tune to a preset radio station Show RDS information EN 3 E n g l i sh 1 Important Safety Know these safety symbols h Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. i Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. j Only use attachments/accessories specified by the manufacturer. This `bolt of lightning' indicates uninsulated material within your unit may cause an electrical shock. For the safety of everyone in your household, please do not remove product covering. [. . . ] Mute or restore volume. 3 Get started Caution · Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. Always follow the instructions in this chapter in sequence. If you contact Philips, you will be asked for the model and serial number of this apparatus. The model number and serial number are on the back of the apparatus. ___________________________ Connect speakers Note · Ensure that the colors of the speaker wires and terminals are matched. · For optimal sound, use the supplied speakers only. v REPEAT · Select a repeat play mode. w Source buttons · Select a source. · DOCK source is not available for this unit. · Connect only speakers with impedance that is the same or higher than the supplied speakers. Refer to the Specifications section of this manual. For the main unit side: Connect the speaker wires and the main unit as the following graphic indicates: 10 EN For the speaker side: For the left speaker, identify the speaker cable that is connected to the left connectors on the main unit. Insert fully the red end of the speaker cable into the red (+) connector. Screw the red (+) connector to secure the cable. Insert fully the silver end of the speaker cable into the black (-) connector. Screw the black (-) connector to secure the cable. Repeat steps 2-6 for the right speaker. Caution · Risk of product damage!» [CLOCK SET] scrolls on the display, then the time format [24H] or [12H] is displayed. Turn on 1 Press . » The unit switches to the last selected source. 2 3 4 5 Press VOL +/- to select 24H or 12H, then press CLOCK to confirm. Press VOL +/- to set hour, then press CLOCK again. » The minute digits begin to blink. Press CLOCK to confirm the clock setting. Note Switch to standby mode To switch the system to Eco Power Standby mode: In standby mode, press and hold for 2 seconds. » [ECO POWER] (Eco power) scrolls on the display, then the backlight turns off. · If no button is pressed in 90 seconds, the system exits clock setting mode automatically. 12 EN 4 Play Basic play operations You can control play through following operations. Key / Function Press and hold to fast-forward/fastreverse the track during playback, then release to resume play. REPEAT To select a repeat play mode: [REP] (repeat): play current track repeatedly. [REP ALL] (repeat all): play all tracks repeatedly. Press again to return to normal play. Play from USB E n g l i sh Warning · Make sure that the USB storage device contains playable audio contents for supported formats. 1 2 3 Flip open the cover marked front panel. on the Play from disc 1 Press DISC to select the CD source. 2 Press . » The disc compartment opens. Insert the USB storage device into the USB socket. [. . . ] If the problem remains unsolved, go to the Philips web site (www. When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available. No power · Ensure that the AC power cord of the unit is connected properly. · Ensure that there is power at the AC outlet. [. . . ]