User manual PHILIPS MMS223

[. . . ] A polarized plug has two blades with one wider than the other. A AC Polarized Plug grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. [. . . ] Romove batteries when the unit is not used for a long time. To change a fuse in this type of plug proceed as follows: 1 Remove fuse cover and fuse. 2 Fix new fuse which should be a BS1362 5 Amp, A. If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. if the mains plug contains a fuse , this should have a value of 5 Amp. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5 Amp. Note: The severed plug must be disposed of to avoid a possible shock hazard should it be inserted into a 13 Amp socket elsewhere. How to connect a plug The wires in the mains lead are coloured with the following code: blue = neutral (N), brown = live (L). As these colours may not correspond with the colour markings identifying the terminals in your plug, proceed as follows: Connect the blue wire to the terminal marked N or coloured black. connect the brown wire to the terminal marked L or coloured red. Do not connect either wire to the earth terminal in the plug, marked E (or ) or coloured green (or green and yellow). Before replacing the plug cover, make certain that the cord grip is clamped over the sheath of the lead - not simply over the two wires. The socket-outlet shall be installed near the equipment and shall be easily accessible. Class II equipment symbol This symbol indicates that the unit has a double insulation system. [. . . ] - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Note: Do not insert the power plug into the AC outlet until all connections are made!1) Headphone For private listening a headphone can be connected 2) Power ON/OFF To switch on or off power 3) Rotary Volume Control To adjust the volume higher or lower 4) Line In To connect the fixed Line In cable to the soundcard/ sound source 5) Power To connect to power supply 6) Radio Turner Change the FM wavelength using the rotary controller 7) Radio ON/OFF To turn just the radio on or off 8) Set Time Button To set the time on the clock (see below) À Press set time button for less À Appuyez sur la touche set than 1 second to advance the time(réglage heure) pendant minute hand. [. . . ]