User manual PHILIPS MX5800SA-21S

[. . . ] Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. Patents and other intellectual property rights owned by Macrovision Corporation and other rights owners. Use of this copyright protection technology must be authorized by Macrovision Corporation, and is intended for home and other limited viewing uses only unless otherwise authorized by Macrovision Corporation. 23 Resuming playback from the last stopped point (DVD/VCD) . [. . . ] Press 3 4 to adjust the values of these parametres that best suit your vision : Gamma, Sharpness, Chrome Delay and DCDi. Gamma Select this allows you to adjust the intensity of the picture non-linearly. A positive value allows you to bring out low level detail in dark scenes, while a negative value will emphasize contrast. Sharpness Select this allows you to adjust sharpness of the picture. Chrome Delay Select this allows you to adjust the advance delay of the chrome signal to yield a perfectly clear picture. Especially when the chrome (colour) and luma (brightness) signals are not synchronised. DCDi (New Directional Correlation Deinterlacing) Select this will optimise the image quality significantly, especially during the slow motion playback. It computes and tracks the angle of edge to fill in the missing pixel on the TV screen. Set Digital Output according to your optional audio equipment connections. Follow the steps of "Using the Setup Menu" and select : Set your PCM (Pulse Code Modulation) output only after you have set the system's Digital Output to `PCM only'. Off PCM only All Off Select this to deactivate the digital output. All Select this if you have connected the digital output to an optional piece of audio equipment that has a multichannel decoder. PCM only Select this if the optional audio equipment is not capable of decoding multichannel audio. The signal will then be converted to a standard signal with sampling rates of 48 kHz. 96 kHz Select this if the optional audio equipment is capable of processing digital signal input with sampling rates of 96 kHz. However, if the sound output is distorted or there is no sound, select `48 kHz' instead. Set Analogue Output to match your DVD home cinema system's playback capability. This function can also be accessed via the SURR. Night mode ­ turning on /off Off Select this when you want to enjoy the surround sound with its full dynamic range. High volume outputs will be softened and low volume outputs are brought upward to an audible level. This feature is only available for movies with Dolby Digital mode. Stereo Select this to change channel output to stereo which delivers sound from only the two front speakers and subwoofer. [. . . ] Multichannel: DVD is specified to have each sound track constitute one sound field. Multichannel refers to a structure of sound tracks having three or more channels. Parental level: A function of the DVD to limit playback of the disc by the age of the users according to the limitation level in each country. The limitation varies from disc to disc; when it is activated, playback will be prohibited if the software's level is higher than the user-set level. [. . . ]