User manual PHILIPS MX999-22S

[. . . ] Additionally to the standard supplies the Home Cinema packages MX 980, MX 999 contain: ­ a subwoofer including a connection cable and a mains cable ­ 5 loudspeakers including 5 speaker cables ­ a coaxial cable for video connection with a DVD player or a TV set ­ a quick installation card For the standard supplies of your receiver see chapter "GENERAL INFORMATION / Scope of supply" in the instruction manual. 2 Check whether the mains voltage as shown on the type plate corresponds to your local mains voltage. If it does not, consult your dealer or service organization. 3 After all connections have been made, connect the AC mains cable to the receiver or the wall outlet. [. . . ] Analogue input is being used for the playing source. Coaxial digital input COAX 1 is being used for the playing source. Coaxial digital input COAX 2 is being used for the playing source. Incoming multi channel signals are being reduced to fewer output signals (depending on the number of speakers). Optical digital input OPTICAL IN is being used for the playing source (FR 984, FR 985, FR 986, FR 994 only). Optical digital input OPTICAL 1 IN is being used for the playing source (FR 995, FR 996 only). Optical digital input OPTICAL 2 IN is being used for the playing source (FR 995, FR 996 only). A rectangle with a letter in it shows that a speaker has been selected in the setup menu. However, the subwoofer indicator will only light when a subwoofer signal is available. If only a letter is shown, this speaker is not used and its sound is reproduced by the other speakers. These signs show you if the menu is on or off and indicate in which direction you may move. You may move backwards to the previous menu topic using 1 PREV. You may move up in an option list using X MENU NAVIGATOR ("up" key on the remote control). You may move down in an option list using X MENU NAVIGATOR ("down" key on the remote control). You may move forward to the next menu topic using NEXT 2 ("right" key on the remote control). This area is used for feedback of the receiver, tuner frequencies, menu options, values and scrolling text messages. The different menu options are related to each other in a logical way. Let's assume you have no center speaker connected, and therefore switched CENTER SPEAKR to NO. If you try to use VOL CENTER, a message will be scrolled that this is not possible (INSTALL CENTER SPEAKER). Arrows in the display show you the possible moving directions. You can exit the menu at any time by pressing SETUP MENU. You can leave any option (values remain unchanged) by pressing 1 PREV. [. . . ] Do not open the set as there is a risk of electric shock. If a fault occurs, first check the points listed, before taking the set for repair. If you are unable to solve a problem by following these hints, consult your dealer or service center. After having let the set cool down switch it on again and select a source by rotating SOURCE SELECT or pressing a source key on the remote control. [. . . ]