User manual PHILIPS NT9141/10

[. . . ] -- If the appliance is subjected to a major change in temperature, pressure or humidity, let the appliance acclimatise for 30 minutes before you use it. -- For hygienic reasons, the appliance should only be used by one person. -- Be careful with hot water when you clean the appliance and the comb. Always check if the water is not too hot, to prevent your hands from getting burnt. [. . . ] Align the locking indicator with the ‘unlocked’ indication (black upward arrowhead) and put the attachment on the handle. Then turn the attachment clockwise until the locking indicator points to the ‘locked’ indication (I). Turn the battery compartment cover from the ‘off’ position (0) to the ‘on’ position (I). 3 Touch the hairs lightly with the precision trimming head and move it against the direction of hair growth. Note:You can use the precision trimming head with the trimmer teeth pointing towards the skin. You can also use it with the flat part touching the skin and the teeth pointing in the direction in which you move the appliance. 4 To switch off the appliance, turn the battery compartment to the ‘off’ indication (0). ENGLISH Trimming with the precision trimming comb With the precision trimming head with precision trimming comb, you can trim hairs to a length of 4mm. 7 1 Put the precision trimming comb on the precision trimming head and push it until it locks into place (‘click’). Turn the battery compartment cover from the ‘off’ position (0) to the ‘on’ position (I). 3 Move the appliance slowly and with light pressure against the direction of hair growth. Note:To make trimming easier, stretch the skin with your free hand during trimming. Note: Make sure that the flat part of the comb always touches the skin to obtain an even result. Note: Do not press the appliance with the comb onto the skin too hard. This may cause the appliance to trim the hairs shorter than the length indicated on the comb. Note: In areas where the hair grows in different directions, move the appliance upwards, downwards and sideways. 4 Regularly remove cut hairs from the comb. If a lot of hairs have accumulated in the comb, detach the comb from the appliance and blow and/or shake the hairs out of it. 5 To switch off the appliance, turn the battery compartment to the ‘off’ indication (0). 6 To detach the comb, put your finger under the bottom edge of the comb and pull it off the appliance. 8 ENGLISH Cleaning Clean the appliance immediately after use and when a lot of hair or dirt has accumulated on the cutting elements. Never use compressed air, scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone to clean the appliance. [. . . ] The appliance works, but the result is uneven. You press the appliance onto the skin too hard. The precision trimming comb is not in full contact with the skin. Solution Clean the precision trimming head (see chapter ‘Cleaning’). [. . . ]