User manual PHILIPS PA9032C

[. . . ] Use a T374AH (RG4172-BK03) remote with its TV Setup, Guest, and Data Communication Mode capabilities to set the TV for the various Commercial mode settings. (Note: On some select Institutional TV models you may also be able to use the buttons at the set to select a Setup Mode. Again, this may not apply or be available on your current model. Commercial setup and verification procedures may be performed which are backward compatible with previous Commercial chassis setup remotes. [. . . ] Press the Cursor Right ( ) or Left ( ) button on the remote to select the amount of time before you want the TV to shut itself off (between 15 minutes and 240 minutes). Press STATUS/EXIT to remove the menu. STOP POWER VIDEO L AUDIO R A V SWITCH 3 POWER SLEEP A/CH STATUS/EXIT CC CLOCK TV RECORD TV/VCR 2 An onscreen countdown will appear on the TV during the last minute before the set is to shut off. A "GOODBYE" message will also show onscreen during the last ten seconds of the countdown. 1 VCR ACC 1 4 7 SMART SOUND 2 5 8 0 3 6 9 SMART PICTURE 2 MENU SURF 3 VOL MUTE CH USING THE SET TIME & CLOCK DISPLAY CONTROLS Y 1 our TV has an on-screen clock. During normal use the clock appears onscreen with every channel change (and when the STATUS button is pressed). BEGIN SMART HELP MAIN MENU CC V-CHIP SETUP SLEEPTIMER SET TIME CLOCK DISPLAY EXIT LANGUAGE CHANNEL INSTALL CABLE TUNING OFF ON 01:45 PM ON ENGLISH ON With the Main Menu onscreen press the Menu button repeatedly , or use the Cursor (v) Up and Down (w) buttons, to select SET TIME with the TV's highlight control bar. Press the Cursor Right ( ) or Left ( ) button on the remote to select the onscreen clock for adjustment. Press the remote's number buttons, or use the Cursor (v) Up and Down (w) buttons, to enter the current time. (Press "0" first for singledigit hour entries. ) Press the STATUS/EXIT button to remove the menu and start the clock. STOP VOLUME CHANNEL POWER VIDEO L AUDIO R A V SWITCH 2 3 POWER SLEEP A/CH STATUS/EXIT CC CLOCK TV RECORD TV/VCR Press the number "1" and "0", or use the Cursor (v)/(w), buttons for the AM/PM clock settings. Remember, in order for the clock to appear on the TV screen, with channel changes, etc. , the CLOCK DISPLAY Menu control must also be set to the ON position. MAIN MENU OFF CC V-CHIP SETUP ON SLEEPTIMER 01:45 PM SET TIME ON CLOCK DISPLAY EXIT ENGLISH LANGUAGE 3 1 VCR ACC 1 4 7 SMART SOUND 2 5 8 0 3 6 9 SMART PICTURE 1 MENU SURF VOL MUTE CH 2 22 HOW TO USE THE ON-SCREEN LANGUAGE OPTION F 1 or our French and Spanish speaking TV owners, an onscreen LANGUAGE option is available. You may set the TV's onscreen menu to appear in either English, French, or Spanish text. BEGIN SMART HELP MAIN MENU LANGUAGE ENGLISH CHANNEL INSTALL CABLE TUNING ON BRIGHTNESS 34 COLOR 22 CONTRAST 29 SHARPNESS 40 TINT 0 NOISE REDUCTION OFF With the Main Menu onscreen press the Menu button repeatedly, or use the Cursor (v) Up and Down (w) buttons, to select LANGUAGE with the TV's highlight control bar. Press the Cursor Right ( ) or Left ( ) button on the remote to select English, French (FRANCAIS), or Spanish (ESPANOL). Text in the onscreen Menu will appear in the selected language. Press STATUS/EXIT to remove the menu. STOP VOLUME CHANNEL POWER VIDEO L AUDIO R A V SWITCH LANGUE CHANNEL INSTALL SYNT. See Smart Help). 3 VIDEO IN (YELLOW) FRONT PANEL AUDIO/VIDEO INPUT JACKS 3 AUDIO IN (RED/WHITE) 4 If you have a single (monaural) Audio Output Camcorder, "Y" connectors are available to complete your connection. Contact your dealer, or local electronic parts supply store, to order optional accessories. AUDIO/VIDEO OUTPUT JACKS ON CAMCORDER CAMCORDER 4 Turn the Camcorder ON and press PLAY to view the tape on the TV. STOP 24 SETTING THE REMOTE CONTROL TO WORK WITH OTHER DEVICES Y our remote control is set to work your TV and many infrared remote (IR) control VCRs, Cable Boxes, Satellite Systems, DBS, DVD, etc. However, an easy onetime step may be necessary before the remote will work your accessory. Try this initial check to see if going on to the following section is necessary. BEGIN VCR SLEEP 1 TV A/CH STATUS/EXIT CC RECORD 1 Place the TV/VCR/ACC Mode Switch in the proper position. Point the remote control at the device and press the POWER button. If YES, stop and try other function buttons on the remote. If they also work the device, then the remote is ready and no further steps are needed. If NO, continue. . . 1 4 7 SMART SOUND 2 5 8 0 3 6 VCR ACC 2 3 Satellite Receiver POWER SLEEP A/CH /EX STATUS IT CC CLOCK TV/VCR TV RECORD 2 SMART PICTUR E VCR ACC SMART Cable Converter SOUND SURF MENU CH VOL MUTE 1 First look up a THREE-DIGIT remote control number for your brand of Device before going through the simple steps on the following page. Find your Accessory Device Three-Digit Codes listed on pages 28-29. SMART HELP Remember, if more than one number is listed, you may have to try more than the first ThreeDigit code given in order to locate your Device's proper remote code. 25 SETTING THE REMOTE CONTROL TO WORK WITH OTHER DEVICES Direct Access Method N ow that you have looked up the three-digit Remote Code Number for your brand of device, you are ready to follow the simple steps shown below. Please read through steps 1-4 before beginning. BEGIN SLEEP 1 VCR ACC 2 STATUS/EXIT CC POWER A/CH CLOCK TV RECORD TV/VCR 1 4 7 SMART SOUND 2 5 8 0 3 6 9 SMART PICTURE 4 1 Place the TV/VCR/ACC Mode Switch in the proper position. [. . . ] 6 Safety/Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3, 34 Sensor (Remote) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Setup Modes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2, 31 Sleep Timer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22 Speaker Terminal Connections . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23 Status Button. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8, 9 Stereo . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 Tips for Service. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 34 V-Chip Content Advisory . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19-21 VCR/TV Connections. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Volume Bar Control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16 Warranty. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 36 LIMITED WARRANTY COLOR TELEVISION One Year Free Labor One Year Free Service on Parts (Two Years Free Service on Color Picture Tube) This product can be repaired in-home. WHO IS COVERED? You must have proof of purchase to receive warranty service. A sales receipt or other document showing that you purchased the product is considered proof of purchase. MAKE SURE YOU KEEP. . . Please keep your sales receipt or other document showing proof of purchase. Attach it to this owner's manual and keep both nearby. [. . . ]