User manual PHILIPS PAC010 QUICK START GUIDE

[. . . ] When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. 13 Unplug this apparatus during lightning storms or when unused for long periods of time. 14 Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. [. . . ] The speaker dock will also go into this mode first when it is turned on by pressing the power button on the back of the speaker dock. In standby mode: The volume touch pads of + and - will display dim blue light to indicate this mode. In this mode, the speaker dock will draw a minimal power from the power supply. Speaker dock will go into active mode again when: · It detects any audio signal from the docking GoGear player or from line-in jack. ⷠPress the volume keys of either the speaker dock or the remote control. In off mode: Press the power button on the back of the speaker to completely turn off the speaker dock. Specifications are subject to change without notice. Trademarks are the property of Koninklijke Philips Electronics N. Problem Possible cause Action No sound GoGear player does not dock Make sure the dock is inserted properly correctly Undock the player, and check for any obstruction on the connectors. No power to the system Make sure AC/DC adapter is connected to the wall outlet and connected to the speaker dock. GoGear player is not in Make sure the player is turned playback mode. No sound for few seconds after docking with GoGear player Few seconds is used for the speaker dock to identify the GoGear model. The remote control does not work Obstacle between remote Eliminate obstacle. Point control and the speaker dock towards the Speaker Dock Battery is empty Change with the new battery. The GoGear player is not in Navigate the GoGear player to music playback mode. The music playback mode via the player buttons. unplug the AC/DC adapter from the speaker dock and plug it again. The GoGear player may hang Remove your GoGear player up from the dock, and perform the reset according to player instruction. Set your GoGear player to playback mode and insert it into the speaker dock on the front. You should hear the music after a few seconds the speaker dock recognize the GoGear player. The volume touch pads of + and - on the dock allow you to adjust the speaker volume. Alternatively, you can use the remote control to adjust the speaker volume and control the music during playback. [. . . ] To change a fuse in this type of plug proceed as follows: 1 Remove fuse cover and fuse. 2 Fix new fuse which should be a BS1362 5 Amp, A. If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. if the mains plug contains a fuse , this should have a value of 5 Amp. [. . . ]