User manual PHILIPS PERSONAL CD AX501217

[. . . ] ­ Remove batteries if they are empty or if the player is not going to be used for a long time. Battery indication The approximate power level of your batteries is shown in the display. battery full Battery two-thirds full Battery one-third full Battery dead or empty. When the batteries are dead or empty, the symbol A flashes, bAtt is displayed, and the beep tone sounds repeatedly. [. . . ] Y Playback continues with the selected track and its number is displayed. Selecting a track when playback is stopped 1 Briefly press or § once or several times. Searching for a passage during playback 1 Keep or § pressed to find a particular passage in a backward or forward direction. Y Searching is started and playback continues at low volume. 2 Release the button when you reach the desired passage. Y Normal playback continues from this very position. ­ During SHUFFLE, SHUFFLE REPEAT ALL, REPEAT or while playing a program, searching is only possible within the particular track. You can select up to 99 tracks and store them in memory in a desired sequence. 1 While playback is stopped, select a track with or §. Y PROGRAM lights up; the track number programmed and P with the total number of stored tracks are displayed. You can review the program by pressing PROGRAM for more than 2 seconds. Y The radio tunes to a station with sufficient strength and radio play starts. 2 Release 3 or 4, then briefly press 3 or 4 again when you are close to the desired frequency. To switch from radio play to CD play press 2;. 2 Press or § if necessary repeatedly to select the number that should be assigned to this radio station. 3 Press PROGRAM while PRESET is blinking to confirm the storing. Y PRESET, the waveband, the frequency and the preset number of the stored station are displayed. 2 Press or § if necessary repeatedly to select the preset number of the desired radio station. PRESET, the waveband, the frequency and the preset number of the stored station are displayed. However CD or tuner play is not conditional upon the time setting. 2 Keep 3 or 4 pressed, then briefly press 3 or 4 again repeatedly within 5 seconds to set the current time. Three times or do not press any key for 5 seconds. [. . . ] Under no circumstances should you try to repair the set yourself as this will invalidate the guarantee. No power, playback does not start Mains adapter Loose connection In-car use Cigarette lighter is not powered when ignition is off. Use FINALIZE on the CD recorder to complete the recording. And/or no reaction Electrostatic discharge Disconnect the set from to controls power supply or take out the batteries for a few seconds. [. . . ]