User manual PHILIPS PERSONAL CD AX511317

[. . . ] Install in accordance with the manufacturers instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Only use attachments/accessories specified by the manufacturer. Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer or sold with the apparatus. [. . . ] 2 Connect the power adapter to the 4. 5V DC jack of the player and to the wall outlet. Note: Always disconnect the adapter when you are not using it. CONTROLS ( see figure 1 ) OPEN 2 . . . . . . . . . . . . . . opens the CD lid . . . . . . . . . . . . . . . . . . . . . . . skips and searches CD tracks backwards § . . . . . . . . . . . . . . . . . . . . . . . skips and searches CD tracks forwards 2; . . . . . . . . . . . . . . . . . . . . . . switches the player on, starts or pauses CD play 9. . . . . . . . . . . . . . . . . . . . . . . . . stops CD play, clears a program or switches the player off DBB. . . . . . . . . . . . . . . . . . . . . switches the bass enhancement on and off. This button also switches acoustic feedback (the beep) on/off when it is pressed for more than 2 seconds . . . . . . . . . . . . . . . . . . . . . . . . . . . . display MODE . . . . . . . . . . . . . . . . . selects the different playing possibilities: shuffle, shuffle repeat all, repeat, repeat all and SCAN PROGRAM . . . . . . . . . . programs tracks and reviews the program RESUME . . . . . . . . . . . . . stores the last position of a CD track played HOLD. . . . . . . . . . . . . . . . . . . locks all buttons OFF. . . . . . . . . . . . . . . . . . . . . . switches RESUME and HOLD off LINE OUT/p. . . . . . . . 3. 5 mm headphone jack and LINE OUT jack to connect the player to another audio input of an additional appliance, remote control (not on all versions) VOL E . . . . . . . . . . . . adjusts the volume 4. 5V DC. . . . . . . . . . . . . . . jack for external power supply . . . . . . . . . . . . . . . . . . . . . . . . . . . . belt clip holder . . . . . . . . . . . . . . . . . . . . . . . . . . . . type plate 4. 5V DC Environmental information · All redundant packing material has been omitted. We have done our utmost to make the packaging easily separable into two materials: cardboard (box) and polyethylene (bags, protective foam sheet). · Your set consists of materials which can be recycled if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packing materials, dead batteries and old equipment. Batteries (supplied or optionally available) You can use the following batteries with this CD-player: · normal batteries type LR6, UM3 or AA (preferably Philips), or · alkaline batteries type LR6, UM3 or AA (preferably Philips). Notes:­ Old and new or different types of batteries should not be combined. ­ Remove batteries if they are empty or if the player is not going to be used for a long time. Inserting batteries 1 Push OPEN 2 to open the CD lid. 2 Open the battery compartment and insert either 2 normal or alkaline batteries. Battery indication The approximate power level of your batteries is shown in the display. 2 Insert an audio CD, printed side up, by pressing the CD onto the hub. 3 Close the player by pressing the lid down. 4 Press 2; to switch the player on and start playback. yThe current track number and elapsed playing time are displayed. · You can pause playback by pressing 2;. yThe time at which playback was paused starts flashing. · You can continue playback by pressing 2; again. yThe total number of tracks and the total playing time of the CD are displayed. 6 Press 9 again to switch the player off. · To remove the CD, hold it by its edge and press the hub gently while lifting the CD. Note: If there is no activity, the set will automatically switch off after a while to save energy. 0 Selecting a track and searching Selecting a track during playback · Briefly press or § once or several times to skip to the current, previous or next track. [. . . ] · To return to normal playback, press MODE repeatedly until the display shows no active modes. ESP / Power Save Mode With a conventional portable CD-player you might have experienced that the music stopped e. g. The ELECTRONIC SKIP PROTECTION prevents loss of sound caused by light vibrations and shocks. However ESP does not prevent playback interruptions during vigorous running. [. . . ]