User manual PHILIPS PORTABLE CD MINI SYSTEM AZ2785

[. . . ] Return your Warranty Registration card today to ensure you receive all the benefits you're entitled to. ⷠOnce your Philips purchase is registered, you're eligible to receive all the privileges of owning a Philips product. ⷠSo complete and return the Warranty Registration Card enclosed with your purchase at once. And take advantage of these important benefits. [. . . ] Make sure you remove the plug from the set and wall outlet before inserting batteries. Open the battery compartment and insert six batteries, type R-20, UM-1 or D-cells, (preferably alkaline) with the correct polarity as indicated by the "+" and "-" symbols inside the compartment. Replace the compartment door, making sure the batteries are firmly and correctly in place. Incorrect use of batteries can cause electrolyte leakage and will corrode the compartment or cause the batteries to burst. When inserting new batteries, do not try to mix old batteries with the new ones. ⷠRemove the batteries if the set is not to be used for a long time. Check if the power voltage as shown on the type plate on the base of the set, corresponds to your local power supply. If it does not, consult your dealer or service center. Connect the power cord to the MAINS inlet and the wall outlet. The power supply is now connected and ready for use. To switch off completely, withdraw the power cord from the wall outlet. ­ Disconnect the power cord from the wall outlet to protect your set during heavy thunderstorms. Switching POWER on/off: Save energy Whether you are using mains or battery supply, to avoid unnecessary energy consumption always push the POWER button to the off position after using the set. REMOVABLE LOUDSPEAKERS Taking off the speakers Keep the lever (found on the back corner of the speaker) pressed and slide the speaker upwards. Attaching the speakers Slide the speakers from above into the sleeves on the sides of the cabinet. Repeat the wiring procedure for the left speaker to terminal L, making sure that you connect the red wire to "+" and black to "-". Note: ­ Speakers with an impedance of 4 Ohms or higher other than as supplied may be used instead. Speakers with a lower impedance, however, are unsuitable and will damage your set. ­ When headphones are inserted into the headphone jack the speakers are disconnected. Operate sound source according to the instructions of the respective chapter about the function. ­ For AZ 2765 model only: The volume level is briefly indicated in the display when you press VOLUME 4 , 3 on the set or remote control. Press POWER to off position to switch off the set. [. . . ] Press PAUSE ; and clean the magnetic heads A and also the capstan B . Cleaning of the heads can also be done by playing a cleaning cassette through once. cD player and CD handling · The lens of the CD player should never be touched! ⷠSudden changes in the surrounding temperature can cause condensation to form and the lens of your CD player to cloud over. [. . . ]