User manual PHILIPS PORTABLE CD PLAYER AX2411-07B

[. . . ] Do not block any of the ventilation openings. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. [. . . ] When playing a CD-Rewritable (CD-RW), please note that it takes 3­15 seconds after pressing 2; for sound reproduction to start. Programming track numbers You can store up to 30 tracks to play in a program. A single track may be stored more than once in the program. 1 While playback is stopped, select a track with or §. Yprogram lights up; the track number programmed and P with the total number of stored tracks are displayed. You can review the program by pressing PROG for more than 2 seconds. yThe display shows all the stored tracks in sequence. Notes: ­ If you press PROG and there is no track selected, SEL is displayed. ­ If you try to store more than 30 tracks, FULL is displayed. RESUME and HOLD You can interrupt playback and continue (even after an extended period of time) from the position where playback stopped (RESUME) and you can lock all buttons of the set so that no action will be executed (HOLD). Use the RESUME­HOLD­OFF slider for these functions. RESUME ­ continuing from where you have stopped 1 Switch the slider to RESUME during playback to activate RESUME. YRESUME is shown and playback continues from where you have stopped. Now, when a key is pressed, no action will be executed. This is of use, for example, when transporting the player in a bag. With HOLD activated, you can avoid accidental activation of other functions. HoLd is shown when you press any button. If the set is switched off, HOLD will be shown only when 2; is pressed. Switches the player on, starts or pauses CD play 2 . Stops CD play, clears a program or switches the player off . This button also switches acoustic feedback (the beep) on/off when it is pressed for more than 2 seconds 5 PROG. 5 mm headphone jack, jack to connect the player to another audio input of an additional appliance. [. . . ] Y SCAN: The first 10 seconds of each of the remaining tracks are played in sequence. 2 Playback starts in the chosen mode after 2 seconds. To return to normal playback, press MODE repeatedly until the display shows no active modes. ESP With a conventional portable CD-player you might have experienced that the music stopped e. [. . . ]