User manual PHILIPS PORTABLE RADIO CASS REC-CD AZ1109

[. . . ] Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Only use attachments/accessories specified by the manufacturer. Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. [. . . ] 3 Firmly connect the headphones to the plug on the remote control. p / + Inserting AA (LR6, UM3) batteries To double playback time, insert AA batteries into the battery compartment and use the AA marked battery door. · Open the battery compartment and insert either 2 normal or alkaline batteries. + - - AA SIZE LR6 / UM3 - + AA (LR6, UM3) 4 On the remote control press 2; to switch on the set and to start playback. 5 Adjust the volume on the CD player or your remote control. Notes: ­ Check the HOLD switch on the remote control is adjusted to the off position if you wish to operate the player using the remote control. Battery indication The approximate power level of your batteries is shown in the display. Battery full Battery two-thirds full Battery one-third full Battery dead or empty. When the batteries are dead or empty, the symbol flashes, bAtt is displayed, and the beep tone sounds repeatedly. POWER SUPPLY / GENERAL INFORMATION Average playing time of batteries under normal conditions Battery type ESP on Power Save Alkaline AA 24 hours 42 hours Alkaline AAA 10 hours 16 hours Rechargeable ECO-PLUS NiMH battery 8. 5 hours 13 hours Batteries contain chemical substances, so they should be disposed of properly. · Do not expose the unit, batteries or CDs to humidity, rain, sand or excessive heat (caused by heating equipment or direct sunlight). · You can clean the CD player with a soft, slightly dampened, lint-free cloth. Do not use any cleaning agents as they may have a corrosive effect. · To clean the CD, wipe it in a straight line from the center toward the edge using a soft, lint-free cloth. Never write on a CD or attach a sticker to it. 1 Push the OPEN 2 slider to open the player. 2 Insert an audio CD, printed side up, by pressing the CD onto the hub. 3 Close the player by pressing the lid down. 4 Press 2; to switch the player on and start playback. yThe current track number and elapsed playing time are displayed. · You can pause playback by pressing 2;. yThe time at which playback was paused starts flashing. · You can continue playback by pressing 2; again. yThe total number of tracks and the total playing time of the CD are displayed. 6 Press STOP again to switch the player off. · To remove the CD, hold it by its edge and press the hub gently while lifting the CD. [. . . ] yresume is shown and playback continues from where you have stopped. · To deactivate RESUME, switch the slider to OFF. HOLD ­ locking all buttons This model offers a double lock function to prevent buttons from being accidentally pressed and activated. You can choose to lock all buttons on either your set, remote control or even both! [. . . ]