User manual PHILIPS PORTABLE RADIO CASS REC-CD AZ1602

[. . . ] Return your Warranty Registration card today to ensure you receive all the benefits you're entitled to. Once your Philips purchase is registered, you're eligible to receive all the privileges of owning a Philips product. So complete and return the Warranty Registration Card enclosed with your purchase at once. And take advantage of these important benefits. [. . . ] Window for showing different CD playing modes 6 CD PLAYER / OPEN . Stops CD play and erases the program PLAY· pAUSE 2; . Starts and interrupts CD play SEARCH § . Plays CD tracks in random order REPEAT . Repeats a track, the entire CD or the program Remove batteries if they are flat or the set is not going to be used for a longer period of time. 1 Check whether the power supply as shown on the type plate corresponds to your local power supply. If it does not, consult your dealer or service organization. the type plate is located on the bottom side of the set. 2 If the set is equipped with a VOLTAGE selector X, set this selector to the local power supply. 3 Connect the power cord to the AC MAINS inlet and the wall outlet. The power cord is inside the battery compartment. The battery AC power supply will be switched off when the set is connected to the mains. to change over to battery supply , withdraw the plug from the unit's AC MAINS inlet. To disconnect the set from the power supply completely, remove the power plug from the wall outlet. The set complies with the FCC-Rules, Part 15 and with 21 CFR 1040. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. The set is switched off when the POWER slider is in position O F F/TAPE and the keys of both tape decks are released. Note: If you run the set on batteries, always be sure to switch the set off after use. This will avoid unnecessary power consumption. The bass frequencies can also be emphasised if you place the set against a wall or shelf. [. . . ] For recording on this set you should use a cassette of the type NORMAL (IEC type I). This deck is not suitable for recording on cassettes of the type CHROME (IEC type II) or METAL (IEC type IV). At the very beginning and end of the tape, no recording will take place in the 7 seconds during which the leader tape passes the recorder heads. Protecting tapes from accidental erasure Keep the cassette side to be protected in front of you and snap off the left tab. [. . . ]