User manual PHILIPS POWERTOUCH PT727/20

[. . . ] PT919 PT866 PT860 PT845 PT739 PT737 PT731 PT730 PT727 PT726 PT725 PT723 PT721 PT720 User manual 2 1 PT919, PT866, PT860, PT845, PT739, PT737, PT731, PT730, PT727, PT726, PT725, PT723, PT721, PT720 ENGLISH 4 DANSK 15 DEUTSCH 26 ΕΛΛΗΝΙΚΑ 37 ESPAÑOL 49 SUOMI 61 FRANÇAIS 72 ITALIANO 84 NEDERLANDS 96 NORSK 108 PORTUGUÊS 119 SVENSKA 131 TÜRKÇE 142 4 ENGLISH Introduction Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. Please read this user manual, as it contains information about the wonderful features of this shaver as well as some tips to make shaving easier and more enjoyable. €1) 1 Protection cap 2 Shaving unit 3 Shaving unit release button 4 Shaver on/off button 5 Shaving head symbol 6 Charging light 7 Charging stand (PT866*/PT739*) 8 Pouch (PT866*) 9 Adapter 10 Cleaning brush 11 Trimmer release slide (PT919/PT866/PT860/PT845/PT739/PT737/ PT731 only) 12 Trimmer (PT919/PT866/PT860/PT845/PT739/PT737/PT731 only) Note:You can find the type number on the back of the shaver. [. . . ] This is normal and not dangerous because all electronics are enclosed in a sealed power unit inside the shaver. 8 ENGLISH Cleaning the shaving unit under the tap 1 Switch off the shaver and disconnect it from the mains. 2 Press the release button to open the shaving unit. 3 Rinse the shaving unit and hair chamber under a hot tap for 30 seconds. Always check if the water is not too hot, to prevent your hands from getting burnt. -- Rinse the hair chamber and the inside of the shaving unit. -- Rinse the outside of the shaving unit. 4 Close the shaving unit and shake off excess water. Be careful not to hit the shaving unit against anything while shaking off excess water. Never dry the shaving unit and the hair chamber with a towel or tissue, as this may damage the shaving heads and the coupling spindles. 5 Open the shaving unit again and leave it open to let the shaver dry completely. Cleaning the shaving unit with the cleaning brush 1 Switch off the shaver and disconnect it from the mains. 2 Press the release button to open the shaving unit. 3 Pull the shaving unit off the shaver. ENGLISH 4 Turn the lock anticlockwise (A) and remove the retaining frame (B). 9 5 Remove and clean one shaving head at a time. Each shaving head consists of a cutter and a guard. Note: Do not clean more than one cutter and guard at a time, since they are all matching sets. If you accidentally mix up the cutters and guards, it may take several weeks before optimal shaving performance is restored. -- Remove the cutter from the shaving guard and clean it with the brush. -- Clean the inside and outside of the shaving guard with the brush. 6 Put the shaving heads back into the shaving unit. [. . . ] -- The built-in rechargeable shaver battery contains substances that may pollute the environment. Always remove the battery before you discard or hand in the shaver at an official collection point. Dispose of the battery at an official collection point for batteries. If you have trouble removing the battery, you can also take the appliance to a Philips service centre. [. . . ]