User manual PHILIPS POWERTOUCH PT920/22

[. . . ] νικα  56 Español  74 Suomi  91 Français  108 Italiano  125 Nederlands  142 Norsk  159 Português  176 Svenska  193 Türkçe  210 6 English Introduction Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. Please read this user manual, as it contains information about the wonderful features of this shaver as well as some tips to make shaving easier and more enjoyable. €1) A Shaver 1 Protection cap 2 Shaving unit 3 Shaving unit release button 4 Trimmer 5 Trimmer release slide 6 Shaver on/off button 7 Shaving head symbol 8 Battery symbol B Charging stand (PT927/PT925/PT923/PT920/PT876/PT875 only) C Adapter D Jet Clean System (PT927CC/PT923CC only) 1 Locking lever 2 Shaver holder 3 Cleaning chamber release button 4 Jet Clean System on/off button 5 Cleaning symbol and ‘fluid low’ symbol 6 Battery symbol E Jet Clean solution (HQ200) F Cleaning brush G Storage pouch (PT927CC/PT927/PT925/PT923CC/PT920/PT876 only) Note:You can find the type number on the back of the shaver. [. . . ] Then lift the Jet Clean System off the cleaning chamber (B). , , The cleaning chamber remains behind. 2 Unscrew the cap from the bottle with Jet Clean solution (HQ200) and remove the airtight seal. € 3 Fill the cleaning chamber with Jet Clean solution (HQ200) up to the MAX indication. note: Make sure the cleaning chamber is always filled above the MIN indication. 4 Place the Jet Clean System back onto the cleaning chamber (‘click’). Make sure that the release buttons snap back into place. When the cleaning chamber is filled with Jet Clean solution,  do not move it to prevent leakage. 5 Put the small plug in the Jet Clean System and put the adapter in the wall socket. , , The shaver holder automatically moves to its highest position. The Jet Clean System is now ready for use. Using the Jet Clean System 1 Place the shaver without protection cap upside down in the shaver holder. Push down the locking lever completely to lock the shaver into place. , , The battery symbol on the Jet Clean System goes on to indicate that the shaver is being charged. Note:The shaver cannot be placed in the Jet Clean System when the protection cap is on the shaving unit. You can simply pour the cleaning fluid down the sink, this is not harmful to the environment. 16 English 5 Fill the cleaning chamber with Jet Clean solution (HQ200) up to the MAX indication. Note: Make sure the cleaning chamber is always filled above the MIN indication. 6 Place the Jet Clean System back onto the cleaning chamber (‘click’). Make sure that the release buttons snap back into place. Cleaning the trimmer with the cleaning brush Clean the trimmer every time you have used it. 1 Switch off the shaver and disconnect it from the mains. [. . . ] The Jet Clean System is not connected Put the small plug in the Jet Clean System to the mains. During rinsing some water may collect between the power unit and the housing. After rinsing this water flows out through the socket. The power unit is completely watertight so water cannot reach the electronic parts of the shaver. [. . . ]