User manual PHILIPS PPX1230

[. . . ] Register your product and get support at www. philips. com/welcome PPX1230 EN User Manual EN Overview Dear Customer Thank you for purchasing our Pocket Projector. We hope you enjoy your device and its many functions! About this User Manual With the installation guide on the following pages, you can start using your device quickly and easily. Detailed descriptions can be found in the following sections of this user manual. Follow all safety instructions in order to ensure proper operation of your device. [. . . ] Never use liquid, gaseous or easily flammable cleansers (sprays, abrasives, polishes, alcohol). Do not allow any moisture to reach the interior of the device. The capacity of the battery diminishes with time. (Power supply) Do not replace the battery yourself On/off switch, general (power supply) Turn off the device before cleaning the surface DANGER! High Power LED This device is equipped with an high power LED (Light Emitting Diode), which emits very bright light. Do not stare directly into the projector lens to avoid eye irritation or injury. 4 Philips · PPX1230 2 Overview Top of the Device , À/Á, ¡/¢, à--Navigation keys / OK key Navigate the menu, modify settings / Confirm entry --Focus wheel for image sharpness. Please pay attention to the distance from the projection surface. If the Pocket Projector is located outside of this range, it will not be possible to focus the image. Turn the focus wheel carefully so as to avoid damaging the lens. , , ¿--One menu step back / cancelling a function . . . ON / OFF--On/Off switch --Battery status monitor: Red: battery empty, Green: battery fully charged Charge indicator with connected power supply: Red: battery empty, Green: battery fully charged DC IN--Power supply connection ^ A/V--Audio/video input jack (composite / CVBS) ­ Connection of a playback device with audio/video output VGA / YPbPr--Component input (YUV/YPbPr) / VGA input ­ Connection of a playback device with component (YUV/YPbPr) output or a computer (VGA audio) for image playback S Ï--Audio output ­ headphone connection or connection for external speakers P2 oben EN Bottom of the Device , Tripod socket Fold-out base PicoPix P3 Bottom Overview 5 EN 3 Initial Operation Connect power supply / charge battery CAUTION! Initial Installation 1 Switch the device on using the on/off switch on the side. 2 Turn the device towards an appropriate projection surface or wall at a distance of at least 0, 2m and at most 3m. Make sure the projector is in a secure position. 3 Use the focus wheel on the top to adjust the image sharpness. 4 Select the desired menu language using ¡/¢. 5 Confirm with à. Mains Voltage at the Site of Installation!Check whether the mains voltage of the power supply matches the mains voltage available at the setup location. 1 Insert the small plug of the power supply into the socket on the rear side of your device. 3 During the charging process, the indicator light on the top of the device will be red. When the battery is fully charged, it will turn green. 4 Charge the built-in battery before using for the first time for at least 3 hours. This will prolong, the life of the battery. Notice The language selection does not appear The device has already been installed. In order to change the menu language, proceed as follows: 1 Press à. 4 Select the desired language with ¡/¢. 6 You can exit with ¿. 6 Philips · PPX1230 4 Connect to the playback device Only use the supplied cable or cables that are available as accessories to connect the projector. EN Supplied Cables Video-(CVBS) cable Connecting using Component-Video (YPbPr/ YUV) Cable Please use this type of connection to get the highest possible quality of image. [. . . ] Please respect the sorting rules set up locally for this kind of waste. Batteries:If your product contains batteries, they must be disposed of at appropriate collection points. Accessories Following accessories are available for your device: YUV /YPbPr Adaptercable . . . . . . . . . PPA 1110 / 253372492 VGA-Audiocable. . . . . . . . . . . . . . . . . . . . . . . . . . . PPA 1150 / 253372489 iPod / iPhone Cable . . . . . . . . . . . . . . . . . . . . . PPA 1160 / 253372471 All data are provided for reference purposes only. Sagemcom reserves the right to make any changes without prior notice. The CE marking certifies that the product meets the main requirements of the European Parliament and Council directive 1999/5/CE on telecommunications terminal equipment, regarding safety and health of users and regarding electromagnetic interference. The declaration of compliance can be consulted on the site www. sagem-ca. at/doc Preservation of the environment as part of a sustainable development logic is an essential concern of Sagemcom. [. . . ]