User manual PHILIPS PQ226/18

[. . . ] Register your product and get support at www. Com/welcome PQ227, PQ226, PQ225, PQ222 1 2 3 4 English Introduction Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. €¯1) 1 Protection cap 2 Shaving heads 3 Shaving unit 4 Hair chamber 5 On/off button 6 Charging light 7 Socket for micro USB plug 8 Wheel of retaining frame 9 Retaining frame 10 Cutter 11 Guard 12 Release button 13 Cleaning brush 14 Adapter 15 Micro USB plug 16 Storage pouch (PQ288 only) 17 Philips Cleaning Spray (HQ110) (Optional) Important Read this user manual carefully before you use the appliance and save it for future reference. [. . . ] Every two months: shaving heads Note: Do not use cleaning agents or alcohol to clean the shaving heads. only use Philips Cleaning Spray (HQ110). 1 Switch off the shaver, remove the adapter from the wall socket and pull the small plug out of the shaver. 2 Press the release button (1) and pull the shaving unit in a straight upward movement off the shaver (2) (Fig. 3 Turn the orange wheel anticlockwise (1) and remove the retaining frame (2) (Fig. 4 Remove and clean one shaving head at a time. Each shaving head consists of a cutter and a guard (Fig. Note: Do not clean more than one cutter and guard at a time, since they are all matching sets. If you accidentally mix up the cutters and guards, it may take several weeks before optimal shaving performance is restored. 5 Remove the guard from the cutter (Fig. 6 Clean the cutter with the shortbristled side of the cleaning brush. Brush carefully in the direction of the arrows (Fig. 7 Clean the guard with the long-bristled side of the cleaning brush (Fig. 8 Put the cutter back into the guard after cleaning (Fig. 9 Put the shaving heads back into the shaving unit (Fig. 10 Put the retaining frame back into the shaving unit (1) and turn the orange wheel clockwise (2) (Fig. 11 Put the shaving unit back onto the shaver (Fig. Use and store the appliance at a temperature between 5°C and 35°C. 2 Put the protection cap on the shaver after use to prevent damage and to avoid dirt accumulation in the shaving heads (Fig. Note: Make sure that the lug of the protection cap covers the release button. 3 Put the shaver in the storage pouch (PQ288 only). Replacement Replace the shaving heads every two years for optimal shaving results. [. . . ] You have not cleaned the shaver well enough or you have not cleaned it for a long time. long hairs obstruct the shaving heads. Solution Clean the shaving heads thoroughly before you continue shaving. see chapter ‘Cleaning and maintenance’. [. . . ]