User manual PHILIPS PRONTO PRO ACCESSORY RF RECEIVER RFX600099

[. . . ] · The RF Extender is placed inside a closet, a rack or another piece of furniture together with your devices (situation C). · The set-ups in situation A, B and C can be combined. If you want to control devices in different locations, you have to place a RF Extender in each location. You can control all RF Extenders with the same Pronto Remote Control. [. . . ] Both send out IR signals simultaneously. This allows you to operate several devices using both the IR blaster and the IR emitters. 4 User Guide Installation How to use the emitters The dual IR emitters can be attached to the surrounding surface facing the receiving eyes or directly to the receiving eyes. 1 Attach the emitters to a surface above, below or in front of the receiving eyes of your devices (for aesthetic appearance or when it is difficult to locate the receiving eye). ­ or ­ Attach the emitters directly to the receiving eyes of your devices. 2 Plug the dual IR emitters into the RF Extender. Note To avoid interference, the wires of the emitters should be kept away from the RF Extender as far as possible. Connecting the Power Adapter When connecting the power adapter it is recommended that you plug the adapter into the RF Extender before you plug it into the socket. When connected you will see a red LED on the RF Extender. Note To avoid interference, the adapter cable should be kept away from the RF Extender as far as possible. User Guide 5 Installation Settings As the RF Extender `communicates' with the Pronto Remote Control, you have to set the same Extender ID (identity) on both appliances. The settings depend on whether you have a single RF Extender or multiple RF Extenders. Single RF Extender When you use only one RF Extender, you can accept the default setting for the Extender ID (ID=0). Make sure your Pronto Remote Control is set to the same default setting (see the Pronto User Guide for more details). Multiple RF Extenders If you want to operate several of your devices independently, e. g. grouped on different locations, you will need multiple RF Extenders. When using several RF Extenders, it is important to assign a unique Extender ID to each RF Extender. 16 Extender IDs (from 0 to 9 and from A to F) can be assigned. 1 Choose an Extender ID for the RF Extender by turning the ID dial with a small screwdriver. 2 On the Pronto Remote Control, choose the same Extender ID for each device controlled by the RF Extender. Refer to the Pronto User Guide for more information. 3 Try to operate your devices with the Pronto Remote Control. The red LED will blink when the RF Extender receives a correct command. 4 Repeat this procedure for every RF Extender. RF Interference If your devices are not responding to commands or if the red LED on the IR blaster is blinking without sending commands, it might be possible that there is RF interference. This can be the case when other RF appliances are operated nearby, for instance at your neighbours. When you notice RF interference, you have to choose another channel on your RF Extender. 4 channels (CH from 0 to 3) can be assigned. [. . . ] Another device in the proximity is sending out RF signals. Change the channel (CH) on the RF Extender (see p. There is no red LED on my RF Extender · Check if the power adapter is connected properly. The dual IR emitters are no longer adhesive · Replace the adhesive with a fresh piece of the 2-sided tape. [. . . ]