User manual PHILIPS PT 725

[. . . ] -- Warning: Do not use this appliance close to a bathtub, shower or other containers filled with water. Caution -- Do not immerse the shaver in water or any other liquid. -- Do not use water hotter than 80°C to rinse the shaver. Always check if the water is not too hot, to prevent your hands from getting burnt. [. . . ] 4 Clean the shaver (see chapter ‘Cleaning and maintenance’). Trimming (PT880, PT860 only) You can use the trimmer to groom your sideburns and moustache. 1 Press the on/off button once to switch on the shaver. English 11 2 Push the trimmer slide downwards to open the trimmer. 3 After trimming, close the trimmer and switch off the shaver. Cleaning and maintenance Warning: Remove the detachable cord from the handheld part before cleaning this part in water. Never use compressed air, scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone to clean the appliance. -- Clean the shaver after every shave for optimal shaving performance. -- Regular cleaning guarantees better shaving performance. -- For the best cleaning results, we advise you to use the Philips Cleaning spray (HQ110). Always check if the water is not too hot, to prevent your hands from getting burnt. Note:Water may leak from the socket at the bottom of the shaver when you rinse it. This is normal and not dangerous because all electronics are enclosed in a sealed power unit inside the shaver. 12 English Cleaning the shaving unit under the tap 1 Switch off the shaver and disconnect it from the mains. 2 Press the release button to open the shaving unit. 3 Rinse the shaving unit and hair chamber under a hot tap for 30 seconds. Always check if the water is not too hot, to prevent your hands from getting burnt. -- Rinse the hair chamber and the inside of the shaving unit. -- Rinse the outside of the shaving unit. 4 Close the shaving unit and shake off excess water. Be careful not to hit the shaving unit against anything while shaking off excess water. Never dry the shaving unit and the hair chamber with a towel or tissue, as this may damage the shaving heads and the coupling spindles. 5 Open the shaving unit again and leave it open to let the shaver dry completely. Cleaning the shaving unit with the cleaning brush 1 Switch off the shaver and disconnect it from the mains. English 13 2 Press the release button to open the shaving unit. 3 Pull the shaving unit off the shaver. 2 1 4 Turn the lock anticlockwise (1) and remove the retaining frame (2). 5 Remove and clean one shaving head at a time. Each shaving head consists of a cutter and a guard. Note: Do not clean more than one cutter and guard at a time, since they are all matching sets. [. . . ] 1 Disconnect the shaver from the mains. 2 Let the shaver run until it stops. 18 English 3 Undo the screws in the back of the shaver and in the hair chamber. 4 Remove the front panel and the back panel. 5 Bend the 6 hooks aside and take out the power unit. [. . . ]