User manual PHILIPS PT 736

[. . . ] This remote control operates the common features of most but not all models and brands of IR Infrared Controlled Video Equipment. This remote may provide functions that are not available on your equipment. Some functions of your particular equipment (e. Menu functions) may not be controlled by this remote. [. . . ] Pressing CHANNEL UP changes direction to forward again. If your product does not respond after you have tried all the codes for your brand, or if your brand is not listed, try searching for your code by following these steps. Press and hold the CODE SEARCH button until the red indicator stays on, then release the CODE SEARCH button. Press the CHANNEL UP button repeatedly (up to 300 times) until the device to be controlled changes channel. the red indicator blinks off with each button press. If you accidentally overshoot the code required, press the CHANNEL DOWN button to backtrack through the library until the device changes channel. Pressing CHANNEL UP changes direction to forward again. The Code Identification Feature allows you to identify the 4 digit library code stored under your device key. For example, if you want to find out what 4 digit code is stored under your TV device key, follow the six steps below: 1. To find the first digit for the code stored under the mode key pressed in step 2, press each numeric key from 0-9 in turn. When the red indicator blinks off the number you pressed is the first digit for the code you are searching for. This method can be applied similarly to any device and is available for all Modes. Note this feature is not supported by all codes. PLAY, PAUSE, STOP, FF, REWIND, and REC) to Punch-Through control from any Mode programmed with TV, SAT or Cable codes to the last VCR, DVD or DVR programmed Mode you used. Normally other types of remotes only punch-through (from another Mode) on the 6 VCR buttons to the device programmed under the VCR Mode button. This is not much use if you are using a DVD programmed under a Mode other than VCR. For example, if you have 2 DVD, VCR or DVR devices programmed into this remote, the last one you accessed on the remote will be the one that has control of the 6 VCR transport buttons when in any other Mode. This feature will not operate if the programmed TV, SAT or Cable code has its own VCR transport button control e. Volume/Mute Control and Punch-Through Feature This remote lets you select which device Mode controls your Volume/Mute buttons. If the programmed "Visual" code has no Volume/Mute operation of its own then those buttons will punchthrough control to the TV Mode device without needing to change to TV Mode. Please refer to the next page for more information. Any Mode chosen for Volume/Mute control MUST have its own Volume/Mute function or the Volume/Mute buttons will do nothing. [. . . ] Line up your remotes (that you're learning from) in front of the Learning remote, on a hard surface approx. The MACRO button, in conjunction with digits 1, 2 and 3, lets you to program and store up to 3 sequences of IR Commands (button-presses) of your choice. one press of the respective Macro digit button results in that sequence of IR commands being sent. Any sequence of commands that you regularly perform can be reduced to two button presses (MACRO button followed by digit 1, 2 or 3 button). [. . . ]