User manual PHILIPS PT877

[. . . ] ақша 107 Lietuviškai 124 Latviešu 141 Polski 157 Română 174 Русский 191 Slovensky 208 Slovenščina 225 Srpski 241 Українська 258 6 English Introduction Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. Please read this user manual, as it contains information about the wonderful features of this shaver as well as some tips to make shaving easier and more enjoyable. €1) A Shaver 1 Protection cap 2 Shaving unit 3 Shaving unit release button 4 Trimmer 5 Trimmer release slide 6 Shaver on/off button 7 Shaving head symbol 8 Battery symbol B Charging stand (PT927/PT925/PT923/PT920/PT876/PT875 only) C Adapter D Jet Clean System (PT927CC/PT923CC only) 1 Locking lever 2 Shaver holder 3 Cleaning chamber release button 4 Jet Clean System on/off button 5 Cleaning symbol and ‘fluid low’ symbol 6 Battery symbol E Jet Clean solution (HQ200) F Cleaning brush G Storage pouch (PT927CC/PT927/PT925/PT923CC/PT920/PT876 only) Note:You can find the type number on the back of the shaver. [. . . ] Note: Make sure that the projections of the shaving heads fit exactly into the recesses. 7 Put the retaining frame back into the shaving unit (A)and turn the lock clockwise (B). 14 English 8 Insert the lug of the shaving unit into the slot in the top of the shaver. Note: If the shaving unit does not close smoothly, check if you have inserted the shaving heads properly and if the retaining frame is locked. Cleaning the shaving unit in the Jet Clean System (PT927CC/ PT923CC only) The Jet Clean System cleans the shaving unit. Preparing the Jet Clean System for use Note: Fill the cleaning chamber before first use and when the ‘fluid low’ symbol flashes to indicate that the fluid level is too low. When the fluid level drops below the minimum level, the cleaning symbol and the ‘fluid low’ symbol start to flash and the shaver holder returns to its starting position 1 Simultaneously press the release buttons on both sides of the cleaning chamber (A). Then lift the Jet Clean System off the cleaning chamber (B). , , The cleaning chamber remains behind. 2 Unscrew the cap from the bottle with Jet Clean solution (HQ200) and remove the airtight seal. € 3 Fill the cleaning chamber with Jet Clean solution (HQ200) up to the MAX indication. note: Make sure the cleaning chamber is always filled above the MIN indication. 4 Place the Jet Clean System back onto the cleaning chamber (‘click’). Make sure that the release buttons snap back into place. When the cleaning chamber is filled with Jet Clean solution,  do not move it to prevent leakage. English 15 5 Put the small plug in the Jet Clean System and put the adapter in the wall socket. , , The shaver holder automatically moves to its highest position. The Jet Clean System is now ready for use. Using the Jet Clean System 1 Place the shaver without protection cap upside down in the shaver holder. Push down the locking lever completely to lock the shaver into place. , , The battery symbol on the Jet Clean System goes on to indicate that the shaver is being charged. Note:The shaver cannot be placed in the Jet Clean System when the protection cap is on the shaving unit. [. . . ] The shaver is not entirely clean after I clean it in the Jet Clean System (PT927CC/ PT923CC only). The cleaning fluid in the cleaning chamber is soiled. Solution Make sure that the projections of the shaving heads fit exactly into the recesses (see section ‘Cleaning and maintenance’). 21 Recharge the battery (see chapter ‘Charging’) or connect the shaver to the mains. [. . . ]