User manual PHILIPS QC5005

[. . . ] Bear in mind that this technique is difficult to master and should only be applied by experienced users. Lift the hair with a styling comb or hold it between your fingers until only the length that needs to be cut sticks out (fig. 3 Cut the hair protruding from the comb or fingers (fig. 4 Continue this procedure and comb frequently to remove cut hair and to check for unevenly cut sections. [. . . ] 3 First comb the hair into the direction of hair growth. 4 Always move the clipper against the direction of hair growth, otherwise it will not cut the hair properly (fig. 5 Move the clipper through the hair slowly. Using the appliance Clipping with comb attachment 1 Slide the comb attachment onto the rails on the appliance until you hear a click (fig. Important Read these instructions for use carefully before using the appliance and save them for future reference. Check if the voltage indicated on the adapter corresponds to the mains voltage in your home before you connect the appliance. This appliance is suitable for mains voltages from 220 to 240 volts. Do not cut off the adapter to replace it with another plug, as this will cause a hazardous situation. If the adapter is damaged, always have it replaced by one of the original type in order to avoid a hazard. Keep the appliance and the adapter dry (fig. Keep the appliance out of the reach of children. 3 Push the middle part of the cutting unit upwards with your thumb until it opens and then pull it off the appliance (fig. Be careful that the cutting unit does not fall to the floor. 4 Clean the cutting unit and the inside of the appliance with the brush supplied (fig. 5 Place the lug of the cutting unit into the slot and push the unit back onto the appliance (fig. 6 Make sure you push the cutting unit back until you hear a click. To use the hair clipper connected to the mains: Switch the hair clipper off, connect it to the mains and wait a few seconds before switching it on. If the battery is completely empty, wait a few minutes before switching the appliance on. Replacement A worn or damaged cutting unit should only be replaced with an original Philips cutting unit. 1 Push the middle part of the cutting unit upwards with your thumb until it opens and then pull it off the appliance (fig. 2 Place the lug of the cutting unit into the slot and push the cutting unit back until you hear a click (fig. Environment Do not throw the appliance away with the normal household waste at the end of its life, but hand it in at an official collection point for recycling. [. . . ] By doing this you will help to preserve the environment (fig. Do not throw the battery away with the normal household waste but hand it in at an official collection point. You can also take the appliance to a Philips service centre, which will remove the battery for you and will dispose of it in an environmentally safe way. 1 Disconnect the appliance from the mains and let the appliance run until the motor stops. [. . . ]