User manual PHILIPS QC5015

[. . . ] Trimming with the beard trimming comb attachment 1 Alwayscombyourbeardormoustachewithafine comb before you start to trim. 3 To set the comb attachment to the desired hair length, press the adjustment button on the back of the appliance (1) and slide the comb attachment to the desired hair length setting (2). [. . . ] Note: If the appliance has not been used for a long time, it must be recharged for at least 10 hours (NiCd battery) or 18 hours (NiMh battery). 5 Move the appliance through the hair slowly. Toclipinthemosteffectiveway, movetheappliance against the direction of hair growth. Make overlapping passes over the head to ensure thattheappliancecatchesallthehairsthatneedto becut. Make sure that the flat part of the hair clipping comb attachmentisfullyincontactwiththescalptoobtain anevencuttingresult. 5 Place the beard trimming comb attachment on the skin and move the appliance slowly over the beard. When you trim your beard for the first time, start atthehighesthairlengthsettingandreducethehair lengthsettinggradually. Totriminthemosteffectiveway, movetheappliance against the direction of hair growth. Trimming at the unique `stubble look setting' 1 To create a `stubble look', trim with the beard trimming comb attachment set to hair length setting 1. Note:When you use the appliance without comb attachment, it cuts the hair very close to the skin. 1 To remove the comb attachment, press the adjustment button (1) and pull the comb attachment off the appliance (2). 8) 2 Before you start to contour the hairline round the ears, comb the hair ends over the ears. [. . . ] 1 Disconnect the appliance from the mains and let the appliance run until the motor stops. 2 Insert a screwdriver into the opening in the bottom of the appliance. [. . . ]