User manual PHILIPS QC 5090

[. . . ] Use, charge and store the appliance at a temperature between 15°C and 35°C. This appliance is suitable for mains voltages from 220 to 240 volts. Do not use the appliance when one of the attachments is damaged or broken as this may cause injury. This appliance is only intended for clipping human scalp hair. [. . . ] The hair length after cutting is only visible when one of the combs is attached. Use the small comb for a length of 3-21 mm and use the large comb for a length of 23-41 mm. Make sure that the arms of the comb attachment have been properly slid into the grooves on both sides. 2 Set the comb to the desired hair length by turning the length lock (Fig. The small comb cuts hair to a length of 3mm, 6mm, 9mm, 12mm, 15mm, 18mm or 21mm. The large comb cuts the hair to a length of 24mm, 27mm, 30mm, 33mm, 36mm, 39mm or 42mm. Tips We advise you to start clipping at the highest setting of the large comb and to reduce the hair length in small steps until you reach the desired hair length. If a lot of hair has accumulated in the comb, remove the comb attachment and blow and/or shake the hair from the comb. Removing the comb does not change the selected hair length setting. Write down the hair length settings used to create a certain hairstyle as a reminder for future clipping sessions. Clipping without comb attachment: You can use the clipper without comb attachment to contour the neckline and the area around the ears. , The comb attachment keeps the cutting unit at a certain distance from your head. This means that, if you use the clipper without the comb attachment, your hair will be cut off very close to the skin. , For precise contouring and defining: 1 Push the middle part of the cutting unit upwards with your thumb until it opens and then pull it off the appliance (Fig. Be careful that the cutting unit does not fall to the floor. 2 Place the lug of the precision trimmer into the slot and push the unit back onto the appliance (`click') (Fig. Cleaning Clean the appliance every time you have used it. Do not use abrasives, scourers or liquids such as alcohol, petrol or acetone to clean the appliance. The appliance and the adapter may only be cleaned with the brush supplied. 1 Make sure the appliance is switched off and disconnected from the mains when you start cleaning it. 3 Push the middle part of the cutting unit upwards with your thumb until it opens and then pull it off the appliance (Fig. Be careful that the cutting unit does not fall to the floor. [. . . ] 2 Push the middle part of the cutting unit upwards with your thumb until it opens and then pull it off the appliance (Fig. Be careful that the cutting unit does not fall to the floor. 3 Remove the upper housing part from the inner part of the appliance by means of a screwdriver (Fig. 4 Separate the lower housing part from the appliance (Fig. [. . . ]