User manual PHILIPS QC-5130

[. . . ] Always here to help you Register your product and get support at www. Com/welcome QC5132 QC5130 User manual 1 ENGLISH 6 ESPAÑOL 15 FRANÇAIS 24 INDONESIA 34 한국어 43 BAHASA MELAYU 52 PORTUGUÊS 61 ภาษาไทย 70 TIẾNG VIỆT 78 繁體中文 87 简体中文 95 111 119 QC5132, QC5130 6 ENGLISH Introduction Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. €1) 1 Pouch (QC5132 only) 2 Hair clipping comb (REGULAR) 3 Length setting selector 4 Cutting element 5 On/off slide 6 CHARGE light 7 Socket for appliance plug 8 Appliance plug 9 Adapter 10 Cleaning brush 11 Hair thinning comb (THINNING) (QC5132 only) Important Read this user manual carefully before you use the appliance and save it for future reference. [. . . ] 2 Comb the hair ends over the ears before you start to contour the hairline. 3 Slide the on/off slide upwards to switch on the appliance. 10 ENGLISH 4 Tilt the appliance in such a way that only one edge of the cutting element touches the hair ends. The hairline has to be close to the ear. 6 To contour the neckline and the sideburns, turn the appliance and make downward strokes. 7 Move the appliance slowly and smoothly. Clipping with the thinning comb (THINNING) Make sure you use the right comb. If you use the hair clipping comb (REGULAR) instead of the hair thinning comb (THINNING), the appliance will clip all hair to the same length. -- With the thinning comb, you can give your haircut a natural look. It also allows you to create a smooth transition between two different hair lengths. -- The thinning comb cuts only half of the hair that enters the comb, which results in a natural look. Thinning an entire haircut We advise you not to use the thinning comb for very short haircuts. 1 Slide the hair-thinning comb into the guiding grooves of the appliance (‘click’). Make sure that you slide the arms of the comb properly into the grooves on both sides. 2 Set the thinning comb to a lower setting than the one you just used for the regular hair clipping comb to create the haircut. Note: How much lower the setting for the thinning comb should be depends on your hairstyle and hair length. Never use the thinning comb at a setting that is lower than half the setting you used to create the haircut. For example,  if you used the large clipping comb at 30mm to create the haircut, do not use the thinning comb at a setting lower than 15mm. ENGLISH 3 Slide the on/off slide upwards to switch on the appliance. 4 Move the hair thinning comb through the hair. Make sure that the thinning comb only touches each spot once, otherwise it cuts all the hair to the set hair length. 11 Creating a smooth transition between two hair lengths If you have cut your hair to two different lengths, you can use the thinning comb to create a smooth transition between these two lengths. [. . . ] -- The built-in rechargeable batteries contain substances that may pollute the environment. Always remove the batteries before you discard and hand in the appliance at an official collection point. Dispose of the batteries at an official collection point for batteries. If you have trouble removing the batteries, you can also take the appliance to a Philips service centre. [. . . ]