User manual PHILIPS QC5340/80

[. . . ] Small and Large Combs Small Comb Barber Setting DANGER of electric shock: To reduce the risk 1.  not reach for a clipper that has fallen into Do water. Do not use while bathing or in a shower.  not place or store clipper where it can Do fall or be pulled into a tub or sink. [. . . ] T Do not use this clipper for any other purpose.  lways store your clipper, attachments and A power plug in a moisture-free area. Make sure the cord is disconnected from the clipper. Only use the power plug supplied with the appliance. 3 If the charge runs low while clipping, the green Charging Light will turn orange. 4 3 w TIP: Write down the settings you have used to create a certain hairstyle as a reminder for future clipping sessions. 1 Unplug electrical cord from outlet and Clipper before dismantling Clipper. 2 Allow Clipper to run until the battery is empty/depleted. 4 Remove any comb and clipping attachment from the handle. 5 Check if there are any screws in the back or front of the appliance. 6 Remove the back and/or front panel of the appliance with a screwdriver. If necessary, also remove additional screws and/or parts until you see the printed circuit board with the rechargeable batteries. If the charge runs out while clipping, connect cord provided to Clipper and outlet. Wait a few seconds and then turn Clipper ON to continue clipping. W Use the Clipper without a comb to clip hair very close to the skin (3/64 in. /1mm) or to contour the neckline and area around the ears. 1 2 Hair Clipping w Use this Clipper for its intended household use as described in this manual. W Make sure that the appliance is fully charged before you start clipping hair. W Before you start clipping, make sure that the head of the person whose hair you are cutting is at the same level as your chest so that all parts of his/her head are clearly visible and within easy reach. W Only use the appliance on clean, dry hair. W Before you begin, comb the hair in the direction of growth (fig. W  achieve optimal clipping results, always move To the appliance slowly through the hair against the direction of hair growth. [. . . ] 3 Slide the selected comb into the guiding grooves on both sides of Clipper and push until you hear it ‘click’ into place (fig. 4  urn the Zoom Wheel Hair Length Setting T Selector to the desired setting (fig. 5 The selected setting number will appear in the Hair Length Settings Window on the Clipper. When you are clipping for the first time, start at the maximum clipping length setting (#6. [. . . ]