User manual PHILIPS QC5570

[. . . ] You can move the clipper over all areas of your head as easily as running your fingers through your hair. To enjoy using the hair clipper, we advise you to read the following information. €1) 1 Cutting element 2 Swivel head 3 Length setting adjustment ring 4 On/off button 5 Socket for small plug 6 Charging lights 7 Regular comb attachment 8 Length setting indicator 9 Precision comb attachment 10 Protection cap of shaving head (only QC5580) 11 Shaving head with retaining frame and shaving foil (only QC5580) 12 Adapter 13 Cleaning brush 14 Storage pouch (only QC5580) Important Read this user manual carefully before you use the appliance and save it for future reference. Danger -- Make sure the adapter does not get wet. [. . . ] Do not turn the cutting element or the comb attachment. Note: Do not turn the swivel head more than 90° to the left or right. -- The swivel head allows you to hold and use the appliance like a styling comb. 4 Press the on/off button to switch on the appliance. QC5580: Press the button more than 2 seconds. 5 Move the clipper through the hair slowly. 6 Regularly remove cut hair from the comb attachment. If a lot of hair has accumulated in the comb attachment, remove the comb attachment from the appliance and blow and/or shake the hair out of it. When you remove the comb attachment, the selected setting does not change. Tips -- We advise you to start clipping at the highest setting of the regular comb attachment and to reduce the setting gradually. -- To clip most effectively, move the appliance against the hair growth direction. 12 English 7 Place the shaving head on your scalp and start shaving. Press the shaving head onto your scalp lightly. Note: Make sure that the shaving foil is always in full contact with your scalp. Cleaning and maintenance Clean the appliance every time you have used it by rinsing it under the tap or with the cleaning brush supplied. Never use compressed air, scouring pads, abrasive cleaning agents or aggressive liquids such as petrol, acetone or ethereal oils to clean the appliance. Be careful that the cutting element does not fall on the floor. Cleaning the cutting element and comb attachments 1 Switch off the appliance and disconnect it from the mains. € 3 mm – 5 – 7 – 9 – 11 – 15 3 Rinse the comb attachment under the tap or clean it with the cleaning brush supplied. 4 Place your thumb in the center of the round side of the cutting element and your index finger on the teeth of the cutting element (1). Use your index finger to lift the cutting element from the swivel head (2). 5 Rinse the cutting element under the tap or clean it with the cleaning brush supplied. [. . . ] Environment -- Do not throw away the appliance with the normal household waste at the end of its life, but hand it in at an official collection point for recycling. By doing this, you help to preserve the environment. -- The built-in rechargeable battery contains substances that may pollute the environment. Always remove the battery before you discard and hand in the appliance at an official collection point. [. . . ]