User manual PHILIPS QG 3193

[. . . ] Introduction Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. 1) A Handle B Setting indicator C On/off switch D Socket for appliance plug E Micro shaver F Hair clipping comb G Setting selector H Nose/ear hair trimmer I Precision timmer J Precision comb K Micro trimmer L Cutting element M Beard trimming comb N Cleaning brush O Adapter P Appliance plug Q Charging light R Stand Important Read this user manual carefully before you use the appliance and save it for future reference. Danger Make sure the adapter does not get wet. [. . . ] Environment - Do not throw away the appliance with the normal household waste at the end of its life, but hand it in at an official collection point for recycling. By doing this, you help to preserve the environment (Fig. Always remove the battery before you discard and hand in the appliance at an official collection point. dispose of the battery at an official collection point for batteries. If you have trouble removing the battery, you can also take the appliance to a Philips service centre. The staff of this centre will remove the battery for you and will dispose of it in an environmentally safe way. 32) Disposal of the battery Only remove the battery when it is completely empty. 1 Disconnect the appliance from the mains and let the appliance run until the motor stops. 2 Remove any comb and/or attachment from the appliance. 6 Cut the wires close to the battery with a pair of household scissors. Do not connect the appliance to the mains again after you have removed the battery. 5 Regularly remove cut hair from the comb. If a lot of hair has accumulated in the comb, remove the comb from the appliance and blow and/or shake the hair out of it. Trimming at the `stubble look' setting 1 To create a `stubble look', trim with the beard trimming comb set to hair length setting 1. 18) Beard trimming without beard trimming comb Use the beard trimmer without the beard trimming comb to contour your beard and to remove single hairs. Cutting without comb results in a very short stubble beard (0. 1 Press the setting selector upwards and pull the beard trimming comb off the handle (Fig. 2 Make careful and controlled movements with the beard trimmer. Touch the hair lightly with the cutting element. Beard trimming with precision trimmer and precision comb Use the precision trimmer with the precision comb to trim smaller areas and to create designer beards. 1 Put the precision trimmer on the handle (see section `Attaching/detaching attachments' in chapter `Preparing for use'). 2 Slide the precision comb into the guiding grooves on both sides of the handle (`click') (Fig. [. . . ] Trimming Preparing for trimming Make sure that the appliance is fully charged before you start trimming. It is not possible to run the appliance from the mains. 1 Comb the hair to be trimmed (beard, moustache, sideburns, eyebrows) with a fine comb. 2 Put the cutting element on the handle (see section `Attaching/detaching attachments' in chapter `Preparing for use'). [. . . ]