User manual PHILIPS QG3020

[. . . ] b Using setting 1 with the comb installed will result in a 'stubble look'. 3 To trim in the most effective way, move the appliance against the direction of hair growth (fig. Make smooth and gentle movements and make sure the surface of the comb always stays in contact with the skin. [. . . ] Charge, use and store the appliance at a temperature between 15cC and 35cC. This appliance is only intended for trimming and grooming the human beard, moustache, sideburns, nose hair, ear hair and eyebrows. Keep the appliance out of the reach of children. Do not use the appliance when one of the attachments is damaged or broken, as this may cause injury. do not place the beard trimmer comb on the precision attachment. Charging Charge the appliance fully before you start using it for the first time or after a long period of disuse. When you charge the appliance for 3 hours, you can use it for 15 minutes. The appliance does not run from the mains. Make sure the appliance is switched off during charging!You can charge the appliance in 2 different ways: 1 In the charging stand: Insert the appliance plug into the socket in the bottom of the stand (fig. The green charging light on the powerplug indicates that the appliance is charging (fig. Optimise the lifetime of the rechargeable battery Do not leave the appliance plugged into the wall socket for more than 24 hours. Discharge the battery completely twice a year by letting the motor run until it stops. Preparing for use Always comb the hair with a fine comb in the direction of growth before you start trimming. [. . . ] If you have trouble removing the battery, you can also take the appliance to a Philips service centre, which will remove the battery for you and will dispose of it in an environmentally safe way. Disposal of the battery 1 Remove the powerplug from the wall socket and pull the appliance plug out of the appliance. Turn the screwdriver to separate the two housing halves (fig. [. . . ]