User manual PHILIPS QG 3060

[. . . ] If the adapter is damaged, always have it replaced with one of the original type in order to avoid a hazard. Do not use the appliance if one of the attachments or combs is damaged or broken, as this may cause injury. This appliance is only intended for trimming the human beard, moustache, sideburns, nose hair, ear hair and eyebrows. If the appliance is subjected to a major change in temperature, pressure or humidity, let the appliance acclimatise for 30 minutes before you use it. [. . . ] - When you trim for the first time, start at the highest setting (9) to familiarise yourself with the appliance. - To create a `stubble look', trim with the beard trimming comb set to hair length setting 1. 2 Switch on the appliance and insert the tip of the Trimmer into one of your nostrils (Fig. To reduce the tickling effect, make sure that you press the side of the tip firmly against the skin. 3 Slowly move the tip in and out while turning it Make sure it is free Round the ear to remove hairs that stick out beyond the rim of the ear (Fig. 3 Carefully insert the tip into the outer ear Do not insert the tip more than 0. 5cm into the ear channel as this could damage the eardrum. trimming eyebrows Use the tip to cut individual eyebrow hairs. Do not use the appliance to define or trim the entire eyebrow. The eyebrow from the base of the nose towards the outer tip of the eyebrow (Fig. Cleaning Never use scouring pads, abrasive cleaning agents or aggressive liquids such as alcohol, petrol or acetone to clean the appliance. Note:The appliance does not need any lubrication. Clean the appliance every time you have used it. Charge the appliance for at least 10 hours before you use it for the first time and after a long period of disuse. when the appliance is fully charged , it has a cordless operating time of up to 35 minutes. Do not charge the appliance for more than 24 hours. note:The appliance is not suitable for mains operation. You can charge the appliance in 2 different ways: Charging in the charging stand Do not move the appliance too fast. Make smooth and gentle movements and make sure the surface of the comb always stays in contact with the skin. If a lot of hair has accumulated in the comb, remove the comb from the appliance and blow and/or shake the hair out of it. [. . . ] If you have trouble removing the battery, you can also take the appliance to a Philips service centre. The staff of this centre will remove the battery for you and will dispose of it in an environmentally safe way (Fig. Removing the rechargeable battery Only remove the rechargeable battery when it is completely empty. 2 Remove any comb and/or attachment from the 3 Insert a screwdriver in the groove next to the shaft at the top of the appliance. [. . . ]