User manual PHILIPS QG 3280

[. . . ] when the appliance is fully charged , it has a cordless operating time of up to 35 minutes. Do not charge the appliance for more than 24 hours. The appliance does not run from the mains. you cannot charge the appliance in the stand. [. . . ] - Always make sure the micro trimmer is fully in contact with the skin. Trimming Preparing for trimming Make sure that the appliance is fully charged before you start trimming. It is not possible to run the appliance from the mains. 1 Comb the hair to be trimmed (beard, moustache, sideburns, eyebrows) with a fine comb. 2 Put the cutting element on the handle (see section `Attaching/detaching attachments' in chapter `Preparing for use'). Beard trimming with beard trimming comb 1 Slide the beard trimming comb into the guiding grooves on both sides of the handle (`click') (Fig. , The setting indicator on the back of the appliance shows the selected setting. Read this user manual carefully before you use the appliance and save it for future reference. Danger Make sure the adapter does not get wet. Warning Check if the voltage indicated on the adapter and on the appliance corresponds to the local mains voltage before you connect the appliance. Do not cut off the adapter to replace it with another plug, as this causes a hazardous situation. 21) , The setting indicator on the back of the appliance shows the selected setting. The table shows how long the hair will be after trimming at the different settings. When you trim for the first time, start at the highest setting (4) to familiarise yourself with the appliance. 2 When you contour eyebrows, stretch the skin of the eyelid (Fig. 3 Make careful and controlled movements with the micro trimmer. - Always move the micro trimmer against the direction of hair growth. - Always make sure the micro trimmer is fully in contact with the skin. Shaving Shaving with the micro shaver Use the micro shaver to create smooth, well-defined contours. Before you use the micro shaver, always check it for damage or wear. If the foil or cutter is damaged or worn, do not use the micro shaver, as injury may occur. If the foil is damaged, replace the top part of the micro shaver and if the cutter is damaged, replace the whole attachment before you use the micro shaver again. [. . . ] - Since all hair does not grow in the same direction, you need to move the appliance in different directions (upward or across). - Make sure that the flat part of the comb is always fully in contact with the skin to obtain an even result. 5 Regularly remove cut hair from the comb. If a lot of hair has accumulated in the comb, remove the comb from the appliance and blow and/or shake the hair out of it. [. . . ]