User manual PHILIPS QT4005-15

[. . . ] Only the cutting unit can be rinsed under the tap. -- Use, charge and store the appliance at a temperature between 5°C and 35°C. -- If the adapter is damaged, always have it replaced with one of the original type in order to avoid a hazard. -- This appliance is only intended for trimming the human beard. [. . . ] See the table below for an overview of the settings and the resulting hair lengths. 6 English Setting 1 2 3 4 5 6 7 8 9 10 Resulting hair length 1mm 2mm 3mm 4mm 5mm 6mm 7mm 8mm 9mm 10mm Note:When you trim for the first time, start at the highest setting (10) to familiarise yourself with the appliance. 3 To trim most effectively, move the trimmer against the hair growth direction. Make sure the surface of the comb always stays in contact with the skin. 4 If a lot of hair has accumulated in the beard  trimming comb, remove the comb and blow and/or shake the hair out of it. The selected setting does not change when you do this. Trimming at the unique ‘stubble look’ setting 1 To create a ‘stubble look’, trim with the beard trimming comb set to setting 1. English Trimming without comb Use the trimmer without beard trimming comb to trim full beards and single hairs. Be careful when you trim without comb because the cutting element removes every hair it touches. 1 Pull the beard trimming comb off the appliance as shown in figure 8. Touch the hair lightly with the trimmer. Cleaning Never use scouring pads, abrasive cleaning agents or aggressive liquids such as alcohol, petrol or acetone to clean the appliance. 1 Make sure the appliance is switched off and disconnected from the mains. 2 Wipe the housing of the appliance with a dry cloth. Never immerse the appliance in water or rinse it under the tap. 3 Remove the trimming comb and clean it with the brush. 4 Remove the cutting unit by pushing against the teeth of the cutting unit and clean it with the brush or rinse it under the tap. 5 Shake off excess water and place the cutting unit back by inserting the lug of the cutting unit into the guiding slot. 6 Push the cutting unit back onto the appliance (‘click’). 8 English Replacement Only replace a worn or damaged cutting unit with an original Philips cutting unit, available from authorised Philips service centres. 2 Remove the old cutting unit by pushing against the teeth of the cutting unit. 3 Insert the lug of the new cutting unit into the guiding slot. [. . . ] If there is no Consumer Care Centre in your country, go to your local Philips dealer. 10 Dansk Introduktion Tillykke med dit køb og velkommen til Philips!For at få fuldt udbytte af den support, Philips tilbyder, skal du registrere dit produkt på www. -- Apparatet bør holdes uden for børns rækkevidde for at sikre, at de ikke kan komme til at lege med det. [. . . ]