User manual PHILIPS QT4015/16

[. . . ] Only the cutting unit can be rinsed under the tap. -- Use, charge and store the appliance at a temperature between 5°C and 35°C. -- If the adapter is damaged, always have it replaced with one of the original type in order to avoid a hazard. -- This appliance is only intended for trimming the human beard. [. . . ] 4 After charging, remove the adapter from the wall socket and pull the appliance plug out of the appliance. 6 English Trimming with comb 1 Turn the Precision Zoom Lock™ adjustment ring to the desired setting. The selected setting is the setting in the centre of the adjustment ring. See the table below for an overview of the settings and the resulting hair lengths. 5mm 10mm Note:When you trim for the first time, start at the highest setting (10) to familiarise yourself with the appliance. 3 To trim most effectively, move the trimmer against the hair growth direction. Make sure the surface of the comb always stays in contact with the skin. 4 If a lot of hair has accumulated in the beard  trimming comb, remove the comb and blow and/or shake the hair out of it. The selected setting does not change when you do this. English Trimming at the unique ‘stubble look’ setting 1 To create a ‘stubble look’, trim with the beard trimming comb set to setting 1. 7 Trimming without comb Use the trimmer without beard trimming comb to trim full beards and single hairs. Be careful when you trim without comb because the cutting element removes every hair it touches. 1 Pull the beard trimming comb off the appliance as shown in figure 8. Touch the hair lightly with the trimmer. Corded trimming If the battery is low, you can also use the appliance from the mains: 1 Switch off the appliance, insert the adapter in the wall socket and wait a few seconds before you switch on the appliance. Cleaning Never use scouring pads, abrasive cleaning agents or aggressive liquids such as alcohol, petrol or acetone to clean the appliance. 1 Make sure the appliance is switched off and disconnected from the mains. 2 Wipe the housing of the appliance with a dry cloth. Never immerse the appliance in water or rinse it under the tap. 3 Remove the trimming comb and clean it with the brush. 8 English 4 Remove the cutting unit by pushing against the teeth of the cutting unit and clean it with the brush or rinse it under the tap. 5 Shake off excess water and place the cutting unit back by inserting the lug of the cutting unit into the guiding slot. [. . . ] 3 Cut the wires close to the batteries with a pair of household scissors. 10 English 4 Remove the printed circuit board with the rechargeable batteries. 5 Cut the battery tabs with a pair of scissors and separate the batteries from the printed circuit board. Do not connect the appliance to the mains again after you have opened it. [. . . ]