User manual PHILIPS QT 4050

[. . . ] Do not cut off the adapter to replace it with another plug, as this causes a hazardous situation. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. Caution Charge, use and store the appliance at a temperature between 5°C and 35°C. [. . . ] When you switch off the trimmer, the battery light flashes orange for a few seconds. Corded trimming When the rechargeable battery is low, you can also run the appliance from the mains. To use the appliance connected to the mains: 1 Switch off the trimmer and connect it to the mains. 2 Wait a few seconds and then switch on the appliance. Note: If the battery is completely empty, wait a few minutes before you switch on the appliance. Using the appliance Beard trimming Always comb your beard or moustache with a fine comb before you start trimming. Trimming with trimming comb The hair length settings are indicated in millimetres on the trimming comb. The settings correspond to the remaining hair length after cutting. the trimming comb cuts hair to a length of 1-18mm. If you trim for the first time, start with the maximum hair length setting (18mm). 4 To trim most effectively, move the appliance against the direction of hair growth (Fig. Note: Make smooth and gentle movements and make sure the surface of the trimming comb always stays in contact with the skin. Note: Do not move the appliance too fast. 5 Switch off the appliance after use and clean it (see chapter `Cleaning'). Trimming without trimming comb Use the trimmer without trimming comb to trim full beards and single hairs. 2 Make well-controlled movements and touch the hair lightly with the cutting unit. Absorbing cut hairs The suction mechanism is activated automatically as soon as you switch on the appliance. It absorbs cut hairs during every kind of use, i. Trimming with and without trimming comb and contouring. We advise you to empty the hair-collection chamber after each trimming session. When you trim long, dense beards, it may also be necessary to empty the hair-collection chamber during the trimming session in order to maintain optimal suction performance (see chapter `Cleaning', section `Hair-collection chamber'). Note:To ensure optimal functioning of the vacuum system, do not cut off more than approx. [. . . ] Follow the steps below to remove the rechargeable battery. 1 Disconnect the appliance from the mains and let the appliance run until the motor stops. 3 Remove the 4 screws inside the hair chamber with a screwdriver (Fig. 4 Pull the hair-collection chamber out of the appliance with some force (Fig. [. . . ]